Cisco SNS-3515-K9 Instalación del software - Página 26
Navegue en línea o descargue pdf Instalación del software para Servidor Cisco SNS-3515-K9. Cisco SNS-3515-K9 38 páginas.
También para Cisco SNS-3515-K9: Manual de instalación (36 páginas)
Imprimir página
Setup CIMC Configuration Utility
The static IPv4 and IPv6 settings include the following:
• The Cisco IMC IP address.
• The prefix/subnet.
For IPv6, valid values are 1–127.
• The gateway.
For IPv6, if you do not know the gateway, you can set it as none by entering :: (two colons).
• The preferred DNS server address.
For IPv6, you can set this as none by entering :: (two colons).
Step 3
(Optional) Use this utility to make VLAN settings.
Step 4
Press F1 to go to the second settings window, then continue with the next step.
From the second window, you can press F2 to switch back to the first window.
Step 5
(Optional) Set a hostname for the server.
Step 6
(Optional) Enable dynamic DNS and set a dynamic DNS (DDNS) domain.
Step 7
(Optional) If you check the Factory Default check box, the server reverts to the factory defaults.
Step 8
(Optional) Set a default user password.
Step 9
(Optional) Enable auto-negotiation of port settings or set the port speed and duplex mode manually.
Note
Auto-negotiation is applicable only when you use the Dedicated NIC mode. Auto-negotiation sets the port
speed and duplex mode automatically based on the switch port to which the server is connected. If you disable
auto-negotiation, you must set the port speed and duplex mode manually.
Step 10
(Optional) Reset port profiles and the port name.
Step 11
Press F5 to refresh the settings that you made. You might have to wait about 45 seconds until the new settings appear
and the message, "Network settings configured" is displayed before you reboot the server in the next step.
Step 12
Press F10 to save your settings and reboot the server.
If you chose to enable DHCP, the dynamically assigned IP and MAC addresses are displayed on the console
Note
screen during bootup.
Use a browser and the IP address of the Cisco IMC to connect to the Cisco IMC management interface. The
IP address is based upon the settings that you made (either a static address or the address assigned by your
DHCP server).
The default username for the server is admin. The default password is password.
To manage the server, see the Cisco UCS C-Series Rack-Mount Server Configuration Guide or the Cisco UCS C-Series
Rack-Mount Server CLI Configuration Guide for instructions on using those interfaces. The links to these documents
are in the C-Series documentation roadmap:
http://www.cisco.com/go/unifiedcomputing/c-series-doc
Install Cisco ISE Software on Cisco SNS Appliances
26
Install Cisco ISE Software on Cisco SNS Appliances