Cisco UCS B260 M4 Nota de instalación y mantenimiento - Página 24
Navegue en línea o descargue pdf Nota de instalación y mantenimiento para Servidor Cisco UCS B260 M4. Cisco UCS B260 M4 46 páginas. Blade server
También para Cisco UCS B260 M4: Nota de instalación y mantenimiento (50 páginas)
Imprimir página
Removing an SSD Drive
Removing an SSD Drive
To remove a drive from a blade server, follow these steps:
Procedure
Step 1
Press the latch inward on the drive front panel. See callout 1 in the following figure.
Step 2
Pull the drive from the slot. See callout 2 in the following figure.
Figure 7: Removing an SSD
Step 3
Place the drive on an antistatic mat or antistatic foam if you are not immediately reinstalling it in another
blade server.
Step 4
Install a blanking panel (N20-BBLKD-7MM) if the slot will remain empty.
Installing an SSD Drive
To install an SSD drive in the blade server, follow these steps:
Procedure
Step 1
Remove the blanking panel, if necessary.
Step 2
With the drive label face up, align the drive with the desired drive bay and insert.
Step 3
Gently slide the drive into the opening in the blade server until the SSD clicks into place and the latch fully
engages.
Step 4
Check the LEDs on the blade server to make sure the drive is functioning as expected.
Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs
16
Servicing the Blade Server