Cisco UCS B420 M4 Nota de instalación y mantenimiento - Página 32

Navegue en línea o descargue pdf Nota de instalación y mantenimiento para Servidor Cisco UCS B420 M4. Cisco UCS B420 M4 38 páginas. Blade server

Installing an Adapter Card in Slots 2 or 3

The network adapters and interface cards share a common installation process. These cards are updated

frequently. Currently supported models that are available for this server are listed in the specification sheets

at this URL:

http://www.cisco.com/en/US/products/ps10280/products_data_sheets_list.html

• Adapter slot 1 (4 x 10 Gb) is for the VIC 1340 or VIC 1240 adapter. No other adapter card can be installed

• Adapter slot 2 (4 x 10 Gb) is for the VIC port expander card or the storage accelerator cards. The port

• Adapter slot 3 (8 x 10 Gb) is for the VIC 1380 or VIC 1280 adapter or the storage accelerator cards.

The VIC 1340 and VIC 1380 adapters require a Cisco UCS 6200 Series Fabric Interconnect or Cisco UCS

6300 Series Fabric Interconnect, and they support the Cisco Nexus 2208XP, 2204XP, and 2348UPQ Fabric

Extender (FEX) modules.

The VIC 1240 and VIC 1280 adapters support Cisco UCS 6100, 6200, and 6300 Series Fabric Interconnects,

and they support the Cisco Nexus 2104XP, 2204XP, 2208XP, and 2304XP FEX modules.

If you switch from one type of adapter card to another, download the latest device drivers and load them into

the server's operating system before you physically switch the adapters. For more information, see the firmware

management chapter of one of the Cisco UCS Manager software configuration guides.

Procedure

Step 1

Position the adapter board connector above the motherboard connector and align the two adapter captive

screws to the standoff posts on the motherboard (callout 1).

Step 2

Firmly press the adapter connector into the motherboard connector (callout 2).

Step 3

Tighten the captive screws (callout 3).

Figure 18: Installing an Adapter Card

Cisco UCS B420 M4 Blade Server Installation and Service Note

in slot 1.

expander can only be used if the VIC 1340 or VIC 1240 is installed.

Servicing the Blade Server