Cisco 1700 series Configuración de - Página 7

Navegue en línea o descargue pdf Configuración de para Pasarela Cisco 1700 series. Cisco 1700 series 34 páginas. Secure firewall management center
También para Cisco 1700 series: Manual de cumplimiento de la normativa e información de seguridad (45 páginas), Manual (15 páginas), Manual de configuración (25 páginas), Nota de aplicación (41 páginas), Solución de problemas de hardware (12 páginas), Manual general (13 páginas), Manual (5 páginas), Manual de inicio rápido (6 páginas), Manual de instalación del hardware (46 páginas)

If you are connecting a Cisco 1700 series router with an ADSL WIC to an RJ-11 wall jack that has

Note

the ADSL pair wired for pins 2 and 5, you must use the lavender crossover cable with the blue stripe.

The crossover cable is orderable as a spare.

The following steps tell how to connect the card, using the standard lavender RJ-11 cable; the steps also

apply to the lavender crossover cable with the blue stripe.

Confirm that router power is still turned off.

Step 1

Connect one end of the cable (RJ-11) to the ADSL port on the card.

Step 2

Connect the other end of the cable to the wall jack (RJ-11) at your site, as shown in

Step 3

Figure 6

Turn on power to the router.

Step 4

The following warning applies to routers that use a DC power supply:

To connect the card to the network, you must configure the ADSL card in the router to the no shutdown

Step 5

state. Enter the no shut command in the router configuration. Verify that the CD LED comes on,

indicating that the card is connected to the network.

Configuring the ADSL Interface

Whenever you install a new WIC, or if you want to change the configuration of an existing interface, you

must configure the interface. If you replace a card that was already configured, the router recognizes it

and brings up the interface in the existing configuration.

Before you configure an interface, have the following information available:

•

OL-3317-03

Connecting an ADSL WIC to a Wall Jack

ADSL port

(RJ-11)

SEE MANU AL

BEFO RE

INSTA LLAT ION

ADSL

RJ-11 cable

Protocols you plan to route on the new interface

IP addresses, subnet masks, network numbers, zones, virtual path identifier/virtual channel

identifier (VPI/VCI) number(s), or other information related to the routing protocol

RJ-11

wall jack

Configuring an ADSL WAN Interface Card on Cisco 1700 Series Routers

Configuring the ADSL Interface

Figure