Epson GT-15000 Series Manual de instalación - Página 19

Connecting the scanner

Connect the scanner to your computer or to another SCSI device

as follows:

Note:

The combination of connectors on the SCSI interface cable you need

varies depending on the maker of your SCSI device and SCSI interface

board.

1. Make sure the scanner, computer, and all other SCSI devices

are turned off and unplugged from the power source.

2. Connect one end of the interface cable to one of the scanner

SCSI connectors until the locks on both sides snap in.

Note:

To connect the scanner to a PC or any other SCSI device, the

total length of cable in the daisy chain must not exceed 3 meters;

otherwise the system may not work properly.

When using the SCSI interface, do not use other interfaces such

as USB or IEEE at the same time.

Caution:

Do not connect the scanner to the computer or other devices

while they are turned on as damage may occur.

SCSI interface connector

Setting up the Scanner