Epson GT-30000 Series Manual de inicio rápido - Página 14

You may need to change the select switch setting according to the SCSI device

connection.

Select switch

W (default)

Connecting the scanner

Use the following steps to connect the scanner to your PC or to another SCSI device.

Note:

The combination of connectors on the SCSI interface cable you need varies depending

on the maker of your SCSI device and SCSI interface board.

1. Make sure the scanner, your PC, and all other SCSI devices are turned off and

unplugged from the power source.

Caution:

Do not connect the scanner to your PC or other devices while they are

turned on, otherwise damage may occur.

2. Connect one end of the interface cable to a suitable scanner SCSI connector until

the locks on both sides snap in.

Note:

To connect the scanner to a PC or any other SCSI device, the total length

of cable in the daisy chain must not exceed 3 meters; otherwise the system

may not work properly.

Make sure no other interface is used.

Before connecting the scanner to a PC, you need to set the select switch.

See "Setting the select switch" on page 13 for details.

3. Connect the other end of the cable to the SCSI port of your PC or another SCSI

device.

SCSI cable

Host adapter is wide SCSI, and there are 50-

pin SCSI cables between host adapter and

scanner.

Except above connection.