Digitus DN-16084 Manual de instalación rápida - Página 2

Navegue en línea o descargue pdf Manual de instalación rápida para Cámara de seguridad Digitus DN-16084. Digitus DN-16084 2 páginas.

 ADJUST FOCAL LENGTH & FOCUS (DN-16083 Only)

Note: The appropriate temperature for focus adjustment is

0˚C ~ 40˚C, and prevent adjusting in moisture

environment.

Step1: Loosen the screw, take the shield off your camera,

and rotate the front cover to remove it

Step2: Find two handles on the camera to adjust focal

length and focus. Move the handle near to the

main board first to find the best surveillance area,

and move the hand near to the lens to adjust the

sharpness of the image.

 CAMERA CONFIGURATION

For advanced configuration of your DIGITUS camera with

DIGITUS NVR, please refer to below for the connection:

Step3: Replace the old desiccant with a new one, supplied

in the package.

Step4: Place the front cover back.

Step5: Slide to mount the shield on the camera before

tightening the screw.

Step1: Connect PC to the HUB connected to your camera(s) with RJ45 network cable.

Step2: Install the "IPScan.exe" from the CD on your computer and use this utility to find the IP address of the camera.

Step3: After searching, set your PC in the same network segment as the specific camera you want to access, such as

"192.168.30.xxx" (xxx could be 0~255) in our example

Step4: Note down the IP address and port number of the camera you want to access, such as "192.168.30.1" and "88" in our

example.

Step5: Open Internet Explorer on the PC, and enter the IP address and port number in the URL column to access the camera.

The format is http://ipaddress:portnum, such as http://192.168.30.1:88 in our example.

 Insert Micro SD Card

Only selected models are equipped with a micro SD card

slot for local video recording.

The data originally saved in the micro SD card (if any) will be

removed after inserting it to the camera.

The camera doesn't support hot-swapping. Please insert or

remove the micro SD card with power disconnected.

Please follow the directions in the below graphic to insert Micro

SD card properly:

Note: It's recommended to use a pair of tweezers for inserting

/ removing Micro SD card.