Cisco ASR 5000 Manual de instalación - Página 10
Navegue en línea o descargue pdf Manual de instalación para Pasarela Cisco ASR 5000. Cisco ASR 5000 33 páginas. Applying power and verifying the installation
También para Cisco ASR 5000: Manual de instalación (18 páginas), Procedimiento de instalación (8 páginas), Manual de instalación (37 páginas)
Imprimir página
Checking the LEDs on the Packet Processing Cards
Table 8: Packet Processing Card Run/Fail LED States
Color
Green
Blinking
Green
Red
None
Packet Processing Card Active LED States
The Active LED on a packet processing card indicates that the software is loaded on the card and that the card
is ready for operation. When the system first boots up, all installed packet processing cards are booted into
standby mode. The system must then be configured as to which packet processing cards should serve as
redundant components (remain in standby mode) and which should function as active components.
The possible states for this LED are described in the following table. If the LED is not green, use the
troubleshooting information in the table to diagnose the problem.
Table 9: Packet Processing Card Active LED States
Color
Description
Green
Card is active.
ASR 5000 System Administration Guide, StarOS Release 21.2
10
Description
Troubleshooting
Card powered with no
None needed.
errors detected.
Card is initializing and/or
None needed.
loading software.
Card powered with
Errors were detected during the Power On Self Tests (POSTs).
error(s) detected.
It is likely that the errors were logged to the system's command
line interface during the boot process.
Monitoring the System for show commands, the outputs of which
will assist in further determining the problem.
System Logs for information on how to view logs.
The SNMP MIB Reference for information on associated status
and alarm conditions.
Card is not receiving
Verify that the POWER LEDs on the PFUs are green. If they are
power.
not, check the PFU power feeds.
Verify that the power source is supplying ample voltage and
current to the chassis.
Verify that the card is properly installed per the instructions in
the ASR 5000 Installation Guide.
If all of the above suggestions have been verified, it is possible
that the packet processing card is not functional. Please contact
your service representative.
Troubleshooting
The first time power is applied to the system, all of the packet processing cards
should be booted into the standby mode. Therefore, this LED should be off.
Troubleshooting