Cisco ASR 5000 Manual de instalación - Página 18

Navegue en línea o descargue pdf Manual de instalación para Pasarela Cisco ASR 5000. Cisco ASR 5000 37 páginas. Applying power and verifying the installation
También para Cisco ASR 5000: Manual de instalación (18 páginas), Manual de instalación (33 páginas), Procedimiento de instalación (8 páginas)

Imprimir página
Cisco ASR 5000 Manual de instalación
Checking the LEDs on the SPIO(s)
Color
None

SPIO Standby LED States

The Standby LED on the SPIO indicates that software is loaded on the card and that it is serving as a redundant
component. For the SPIO installed in slot 25, this LED is illuminated steady green during normal operation.
For the SPIO installed in slot 24, this LED is off during normal operation.
If the LED is not green, use the troubleshooting information in the table to diagnose the problem.
Table 13: SPIO Standby LED States
Color
Green
None

SPIO Interface Link LED States

The Link LED, associated with a particular SPIO interface indicates the status of the network link. This LED
is illuminated steady green during normal operation.
If the LED is not green, use the troubleshooting information in the table to diagnose the problem.
Important
During system startup, some Link and/or Activity LEDs may momentarily illuminate. This activity is
normal and does not indicate any network link or data transfer status. The line card has not yet been
initialized and placed into a stable operational state by the system.
ASR 5000 Installation Guide
18
Description
Troubleshooting
Card is not receiving
Verify that the Run/Fail LED is green. If so, the card is receiving
power.
power and POST test results are positive. If it is off, refer to
Run/Fail LED States, on page 16
OR
Card is in Standby Mode.
Check the state of the Standby LED. If it is green, the card is in
standby mode. Refer to the System Administration Guide for
information on making the card active
Description
Troubleshooting
Card is in redundant
None needed for SPIO in slot 25. If green for SPIO in slot 24,
mode
check the status of the SMC installed in slot 8.
If the SMC in slot 8 is in standby mode, it is possible that there
is a configuration problem.
Card is not receiving
Verify that the Run/Fail LED is green. If so, the card is receiving
power.
power and POST test results are positive. If it is off, refer to
Run/Fail LED States, on page 16
OR
Card is in Active Mode.
Check the state of the Active LED. If it is green, the card is in
active mode.
Applying Power and Verifying the Installation
for troubleshooting information.
for troubleshooting information.
SPIO
SPIO