Cisco AT&T 3G MicroCell Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Pasarela Cisco AT&T 3G MicroCell. Cisco AT&T 3G MicroCell 20 páginas. Wireless signal booster
También para Cisco AT&T 3G MicroCell: Manual de introducción (11 páginas), Manual del usuario (20 páginas), Manual de inicio rápido (8 páginas)

Cisco AT&T 3G MicroCell Manual del usuario
Option B
AT&T 3G MicroCell™
Remove the sticker that covers the rear panel of your 3G MicroCell.
To ensure success, it is important to complete the steps below in order.
1.
Disconnect
your current
on the 3G MicroCell.
2. Take the
yellow Ethernet cable
labeled
`Ethernet'
on the 3G MicroCell and the other end to the
3. First,
turn off power
equipment in the following order:
a) Modem
b) 3G MicroCell
(Do this last
the 3G MicroCell and connect the other end to an
10
High Speed Internet with Modem Attached to Computer
1
2
3
Power
Connect AC power adapter last.
Note: If you normally use a USB cable to connect to your modem and computer,
refer to 'Connect Your Devices with USB Cables?' on page 8 for cabling alternatives.
Ethernet cable from the modem
that came with the 3G MicroCell and connect one end to the yellow port
to your current internet equipment.
– connect one end of the
This end is attached
to your computer.
Do NOT unplug.
2
Ethernet Cable
(Included)
and reconnect it to the black port labeled
Ethernet port on your
Wait 1
minute, then
turn on power
AC Power Adapter
to the port labeled
AC
outlet.)
Advance to page 12.
Open Port
Modem
`Computer'
port
modem.
to your Internet
'Power'
on