Cisco VG202 Manual de configuración del software - Página 46
Navegue en línea o descargue pdf Manual de configuración del software para Pasarela Cisco VG202. Cisco VG202 50 páginas. Voice gateways
También para Cisco VG202: Manual de instalación del hardware (50 páginas), Manual (10 páginas), Manual de instalación del hardware (48 páginas), Manual de inicio rápido (19 páginas)
Console Download
Console Download
You can use console download, which is a ROM monitor function, to download either a software image
or a configuration file over the voice gateway console port. After download, the file is either saved to
the mini-flash memory module or to main memory for execution (image files only).
Use console download when you do not have access to a TFTP server.
If you want to download a software image or a configuration file to the voice gateway over the console
Note
port, you must use the ROM monitor dnld command.
If you are using a PC to download a Cisco IOS image over the voice gateway console port at
Note
115,200 bps, ensure that the PC serial port is using a 16550 universal asynchronous transmitter/receiver
(UART). If the PC serial port is not using a 16550 UART, we recommend using a speed of 38,400 bps
or less when downloading a Cisco IOS image over the console port.
Command Description
The following are the syntax and descriptions for the xmodem console download command:
xmodem [-c-y] destination_file_name
c
y
destination_
file_name
Follow these steps to run Xmodem:
Move the image file to the local drive where Xmodem will execute.
Step 1
Enter the xmodem command.
Step 2
Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide
A-6
Optional. Performs the download using 16-bit cyclic redundancy check (CRC-16) error
checking to validate packets. Default is 8-bit CRC.
Optional. Sets the voice gateway to perform the download using Ymodem protocol. The
default is Xmodem protocol. The protocols differ as follows:
Xmodem supports a 128-block transfer size. Ymodem supports a 1024-block
•
transfer size.
Ymodem uses CRC-16 error checking to validate each packet. Depending on the
•
device that the software is being downloaded from, this function might not be
supported by Xmodem.
Name of the system image file or the system configuration file. In order for the voice
gateway to recognize it, the name of the configuration file must be voice
gateway_confg.
Appendix A
Using the ROM Monitor
OL-16191-01