Cisco VG202 Manual de instalación del hardware - Página 33

Navegue en línea o descargue pdf Manual de instalación del hardware para Pasarela Cisco VG202. Cisco VG202 48 páginas. Voice gateways
También para Cisco VG202: Manual de configuración del software (50 páginas), Manual de instalación del hardware (50 páginas), Manual (10 páginas), Manual de inicio rápido (19 páginas)

Chapter 3

Installing the Voice Gateway

Mounting the Chassis onto a Wall

The following warning applies only when the voice gateway chassis is mounted on a wall:

This unit is intended to be mounted on a wall. Please read the wall-mounting instructions carefully

Warning

before beginning installation. Failure to use the correct hardware or to follow the correct procedures

could result in a hazardous situation to people and damage to the system. Statement 248

You can mount the chassis onto a wall or other vertical surface by using the molded mounting-screw slots

on the bottom of the chassis and two number-six, 3/4 inch (M3.5 x 20 mm) screws. You must provide

the screws.

Figure 3-2

Before You Begin

Ensure that you meet the following conditions when you mount the chassis onto a wall:

•

OL-15959-01

Figure 3-2

shows the mounting-screw slots.

Mounting-Screw Slots for Mounting a Cisco VG202, Cisco VG202XM, Cisco VG204, or

Cisco VG204XM Voice Gateway Chassis onto a Wall

Rubber feet

The LEDs on the front panel face upward and are easily visible, because you will use the LEDs as

status and problem indicators.

The back panel faces downward, to reduce strain on the cable connections.

The power supply rests on a horizontal surface such as the floor or a table. If the power supply is

not supported, it can place strain on the power supply cable and cause it to disconnect from the

connector on the back panel of the chassis.

Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM Voice Gateways Hardware Installation Guide

Mounting-screw slots

3-5