Cisco VG400 series Instalación de - Página 11

Navegue en línea o descargue pdf Instalación de para Pasarela Cisco VG400 series. Cisco VG400 series 13 páginas. Voice gateway
También para Cisco VG400 series: Manual de instalación del hardware (40 páginas), Manual de configuración del software (22 páginas)

Imprimir página

Installing the Cisco VG400 Voice Gateway

DETAILED STEPS

Step 1

Power on your terminal or PC, and configure it for 9600 bps, 8 data bits, 1 stop bit, and no parity.

Step 2

Move the Cisco VG400 Voice Gateway power switch to the ON position.

The green LED next to the auxiliary port comes on and the fan starts to operate. If this does not happen, see the

Troubleshooting

The following message is displayed at the end of the boot-up messages:

Example:

--- System Configuration Dialog ---

Would you like to enter the initial configuration dialog? [yes/no]:

Step 3

Enter no to proceed with manual configuration using the CLI:

Example:

Would you like to enter the initial configuration dialog? [yes/no]: no

Would you like to terminate autoinstall? [yes]

Step 4

Press Return to terminate autoinstall and continue with manual configuration.

Several messages are displayed, ending with a line similar to the following:

Example:

...

Compiled <date

> <time

> by <person

Step 5

Press Return to bring up the Router> prompt:

Example:

...

flashfs[4]: Initialization complete.

Router>

Step 6

Enter privileged EXEC mode:

Example:

Router> enable

Router#

Step 7

Continue with the

If the rommon 1> prompt appears, your system has booted in ROM monitor mode. For information on the

Note

ROM monitor, refer to the router rebooting and ROM monitor information in the Cisco IOS Configuration

Fundamentals Configuration Guide for your Cisco IOS software release.

section.

Troubleshooting

section.

Installing the Cisco VG400 Voice Gateway

Power-On Procedure