Epson DLQ-3500 Manual rápido - Página 6

Navegue en línea o descargue pdf Manual rápido para Accesorios para impresoras Epson DLQ-3500. Epson DLQ-3500 32 páginas. Epson serial impact dot matrix printers
También para Epson DLQ-3500: Manual de instalación (31 páginas), Aviso (1 páginas), Manual de referencia (34 páginas)

Imprimir página

Overlapping forms

This setting takes effect only when the

skip-over-perforation setting is on. When

overlapping-forms setting is on, the printer

lifts up the print head each time it makes a

one-inch margin with the

skip-over-perforation feature. You need to

turn on both the overlapping-forms and the

skip-over-perforation settings when you use

overlapping forms.

Changing default settings

Note:

❏ To print the language selection and

default-setting mode instructions, you need

three sheets of A4 or letter size single-sheet

paper or three pages of continuous paper that

is at least 279 mm (11 inches) long and 210

mm (8.3 inches) wide. See "Continuous

Paper" and "Single Sheets with the Paper

Guide" for instructions on loading

continuous paper and single sheets.

❏ If you use single sheets, you need to load a

new sheet of paper each time the printer ejects

a printed sheet from the paper guide.

1. Make sure paper is loaded and the

printer is turned off.

Caution:

Whenever you turn off the printer,

wait at least five seconds before

turning it back on; otherwise, you

may damage the printer.

2. Turn on the printer while holding down

the Font button.

The printer enters the default-setting

mode and prints the language selection

instructions (one page).

EPSON DLQ-3500 Quick Guide

3. Press the Font button until the Font and

Pitch lights indicate the language you

want, as described in the language

selection instructions.

4. Press the Tear Off/Special Paper

button to print the default-setting mode

instructions (two pages) in the language

you selected.

The printed instructions list the settings

you can change, describe how to change

them, and show you how the control

panel lights help you make settings. Use

these instructions to change the printer's

default settings from the control panel.

Note:

The arrows in the instructions indicate the

printer's current settings.

5. When you finish making settings, turn

off the printer and exit the

default-setting mode.

Note:

You may exit the default-setting mode by

turning off the printer at any time. Any

settings you have made remain in effect until

you change them again.

Default Settings (4/4)