Epson FX-880+ Manual rápido - Página 10

Navegue en línea o descargue pdf Manual rápido para Accesorios para impresoras Epson FX-880+. Epson FX-880+ 33 páginas. Epson serial impact dot matrix printers
También para Epson FX-880+: Manual de instalación (33 páginas), Folleto y especificaciones (24 páginas), Manual (18 páginas), Especificaciones (2 páginas), Lea esto primero (2 páginas), Manual de referencia (34 páginas)

4. Slide the left sprocket approximately 12

mm (0.5 inch) from the far left position

and push the blue lever back to lock it in

place. Then slide the right sprocket to

match the width of your paper, but do

not lock it. Move the center support

midway between the two sprocket units.

* approx. 12 mm (0.5 inch)

The triangle mark on top of the printer

indicates the point furthest to the left where

printing can begin.

5. Make sure your paper has a clean,

straight edge. Then open both sprocket

covers and fit the first four holes of the

paper, with the printable side down,

over the tractor pins.

6. Close the sprocket covers.

Downloaded from:

http://www.usersmanualguide.com/

EPSON FX-880+/FX-1180+ Quick Guide

7. Slide the right sprocket to remove any

slack in the paper; then lock it in place by

pushing the blue sprocket lock down.

8. Attach the paper guide and lay it flat on

the printer. Open the edge guides all the

way to the left and right, then raise the

continuous paper support.

9. Turn on the printer. When the printer

receives data, it automatically loads the

paper and starts printing.

If the first line on your page appears too high

or low, you can change its position using the

Micro Adjust function as described in

"Micro Adjust Function."

Caution:

Never use the knob to adjust the

top-of-form position; this may damage the

printer or cause it to lose the top-of-form

position.

Continuous Paper with the Rear Push Tractor (2/2)