TomTom LINK 310 Manual
Navegue en línea o descargue pdf Manual para Mando a distancia TomTom LINK 310. TomTom LINK 310 5 páginas. Logbook
También para TomTom LINK 310: Manual del usuario (46 páginas)
Imprimir páginaPairing TomTom Remote LINK
You need to pair your TomTom Remote LINK with a TomTom LINK 300/310
Pairing TomTom Remote LINK
before you first use the device. This is required because the Remote LINK
transmits your input to the LINK 300/310 without saving the information.
There are two ways to pair your Remote LINK with the LINK 300/310 which are
described in this document. TomTom WORK certified sales partners can also
use the activation tool, visit www.tomtomwork.com/activationtool
Important: A Remote LINK can only be paired with one LINK 300/310. If your
Remote LINK or the LINK 300/310 has already been paired with another
device, both devices need to be reset before pairing with a new device.
Instructions on how to reset both devices are described in this document.
Pairing Remote LINK to LINK 300/310
You can pair the Remote LINK with a LINK 300/310 by only using the two
devices.
1. Make sure the LINK 300/310 is properly installed in the vehicle.
2. Switch on the ignition.
3. Make sure there are no other vehicles installed with a LINK 300/310 located
within a distance of 30 metres.
4. Press any button on your Remote LINK to switch it on.
If the LEDs on all three buttons are flashing, then the device is not paired
and you need to continue with the next step. Otherwise reset your Remote
LINK.
5. Press any two buttons at the same time until you hear a sound.
Remote LINK starts searching for your LINK 300/310 and the blue
Connection LED begins to flash rapidly. Searching may take about one
minute before a connection is established.
Note: To check if a connection has been established press any key.
1