Crow FW2-SIREN2EXT-8/9F Manual de instalación - Página 8
Navegue en línea o descargue pdf Manual de instalación para Sistema de seguridad Crow FW2-SIREN2EXT-8/9F. Crow FW2-SIREN2EXT-8/9F 19 páginas. Siren system
Imprimir página
- User Guide
STEP 3 : Learning the Sirens
Up to 8 Siren units can be activated by single Transceiver. In BUS Mode, these Sirens can be
divided to two groups (A&B) for activating their Sirens (by receiving two separate activation
controls).
Instruction
Place the Siren Units on a flat
1
surface
2
Connect Piezo Siren cable
Connect battery cable
3
4
Verfiy Siren Tampers are open
Set Jumpers B and C according
to Table 1
5
Transceiver
6
Siren
7
8
Close the Siren tampers
Function Testing after learning.
After the learning completed and before the installation verify that the Siren Units
are functioning as defined.
<Learn/Test>
<Learn>
Perform Arm/Disarm verify beep/flash indications.
Perform an Alarm; verify Piezo and Flash are activated.
Perform Alarm Reset via the Keypad by User pin code.
Description
To verify back tamper is closed.
The Siren will beep once and then the LED power will
blink for a period of 30 seconds, please wait to the end
of the blinking before activating or learning.
Siren tampers must be open during the leaning mode
Low Battery indication's beeps and flashes will be "on"
no matter what the status of Mode Jumpers B and C.
On the Transceiver press Learn/Test button.
Green and RED LED on Transceiver starts flashing.
On the Siren press Learn button. Green LED on the
Transceiver turns to solid "ON" for 1 to 3 seconds and
then turns OFF. The Siren is learned by the Transceiver.
6