Epson Stylus Color 670 Información sobre el producto - Página 5

Navegue en línea o descargue pdf Información sobre el producto para Accesorios para impresoras Epson Stylus Color 670. Epson Stylus Color 670 12 páginas. Product support bulletin(s)
También para Epson Stylus Color 670: Hoja de información del producto (4 páginas), Manual de instalación (17 páginas), Hoja de información del producto (4 páginas), Boletín de asistencia sobre productos (6 páginas), Boletín de asistencia sobre productos (1 páginas), Especificaciones (2 páginas), Boletín de asistencia sobre productos (3 páginas), Boletín de asistencia sobre productos (2 páginas), Boletín de asistencia sobre productos (4 páginas), Boletín de asistencia sobre productos (7 páginas)

2. Lift up the two ink cartridge clamps.

3. Unwrap the ink cartridges, then remove only the yellow

part of the tape seal on top. Don't pull off the blue part.

black cartridge

(S020187)

4. Insert both ink cartridges with the labels facing up as

shown. Press down on the clamps until they lock into place,

but don't press down on the ink cartridges themselves.

5. Press the R cleaning button and close the printer cover.

Ink charging takes about a minute and a half, with the

P power light flashing and the printer making noise until it's

finished. Don't turn off the printer or interrupt charging or it

will start over, using more ink than necessary. It's finished

when the P power light stops flashing.

Testing the Printer

You can run a printer check to determine whether a problem

comes from the printer itself or some other source. Follow

these steps to run the printer check:

1. Make sure both the printer and computer are turned off.

2. Disconnect the interface cable from the printer.

3. Make sure paper is loaded in the printer.

4. Hold down the E load/eject button, then press and release

the Ppower button. Continue holding down the

E load/eject button until the P power light starts to flash,

then release it.

The printer prints one page showing its ROM version

number, ink counter, and a nozzle check pattern. Only the

nozzle check pattern is shown below. (If the pattern has

gaps in its dots, you need to clean the print head; see

page 8.)

color cartridge

(S020191)

5. To end the check, turn off the printer after it prints the

check page. Then reconnect the interface cable and turn on

your printer and computer.

If the check page prints, the problem probably lies in your

software settings, the interface cable, or your computer.

If the check page doesn't print, you may have a problem with

your printer. Try the suggestions in "Problems and Solutions"

in the Printer Basics book.

2/00

EPSON Stylus COLOR 670

- 5