Epson Stylus Color 670 Información sobre el producto - Página 8

Navegue en línea o descargue pdf Información sobre el producto para Accesorios para impresoras Epson Stylus Color 670. Epson Stylus Color 670 12 páginas. Product support bulletin(s)
También para Epson Stylus Color 670: Hoja de información del producto (4 páginas), Manual de instalación (17 páginas), Hoja de información del producto (4 páginas), Boletín de asistencia sobre productos (6 páginas), Boletín de asistencia sobre productos (1 páginas), Especificaciones (2 páginas), Boletín de asistencia sobre productos (3 páginas), Boletín de asistencia sobre productos (2 páginas), Boletín de asistencia sobre productos (4 páginas), Boletín de asistencia sobre productos (7 páginas)

Imprimir página

EPSON Stylus COLOR 670

3. Pull up the ink cartridge clamp. The cartridge rises up from

its holder. (The illustration shows color ink cartridge

replacement. To replace the black ink cartridge, lift up only

the smaller clamp on the left.)

Keep ink cartridges out of the reach of children and don't

drink the ink.

If ink gets on your hands, wash them thoroughly with

soap and water. If ink gets into your eyes, flush them

immediately with water.

4. Lift the cartridge out of the printer and dispose of it

carefully.

5. Unwrap the new ink cartridge. Then remove only the yellow

part of the tape seal on top.

black cartridge

(S020187)

You must remove the yellow tape from the top of the

cartridge or you will permanently damage it and a printer

error will occur. Don't pull off the blue portion or try to

remove the clear seal underneath the cartridge.

8 - EPSON Stylus COLOR 670

6. Lower the new ink cartridge into its holder with the label

facing up and toward the back of the printer. Then press

down the ink cartridge clamp until it locks in place, but

don't press down on the cartridge itself.

7. If you need to replace the other ink cartridge, repeat steps 3

through 6 before continuing with step 8.

8. Press the E load/eject button again and close the printer

cover. The printer moves the print head and begins

charging the ink delivery system.

The P power light flashes and the printer makes noise.

Charging takes about 30 seconds. When it's finished, the

P power light stops flashing and stays on.

Cleaning the Print Head

If your printed image is unexpectedly light or faint, or dots are

missing from the image, you may need to clean the print head.

This unclogs the nozzles so they can deliver ink properly.

Cleaning the print head uses ink, so clean it only if print

quality declines. You can clean the print head in either of the

following ways:

using the Head Cleaning utility (when the printer is

connected to a local port, not over a network)

using the printer's control panel buttons

Both methods are described on the next page.

color cartridge

(S020191)

2/00

Never turn off the printer while the P power light is

flashing, unless the printer hasn't moved or made noise

for more than 5 minutes.

When you don't turn on your printer for a long time, the

print quality can decline. It's a good idea to turn on your

printer at least once a month to maintain good print

quality.

If any paper you buy comes with a cleaning sheet, don't

use the cleaning sheet with your printer; it may jam

inside the printer.