Crowcon Clip+ Manual de instalación y funcionamiento - Página 14

Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Instrumentos de medida Crowcon Clip+. Crowcon Clip+ 15 páginas. Fixed life single gas monitor

Imprimir página

After you have made your requested changes click on the Write Device Button. If a successful write has

occurred you will see a green bar at the bottom (see above).

8.6. Firmware Upgrade

Both the Clip & Clip+ monitors allow for Firmware upgrades to occur during the lifetime of the unit.

These may be product improvements to add additional features or to enhance monitor performance.

Most firmware upgrades are not required unless notified by Crowcon.

In order to perform a firmware upgrade, make sure to position your monitor in front If the IR reader as

instructed in the "Getting Started" section. Be sure to read the device before performing any

upgrades to insure a connection has been established.

Once a successful read has occurred, click on the Folder Icon located in bottom middle right. Select the

firmware file you would like to upgrade to and then click Upgrade Firmware. This process will take

approx 30 seconds to perform. DO NOT move the unit during a firmware upgrade. Once a successful

upgrade has occurred a green bar will appear with "download image...ok". Firmware upgrades may

also be performed through the Clip Dock Docking station.

8.7. Hibernating Clip+

Your Crowcon Clip+ unit allows you to place the monitor in hibernate mode when it is not being used. In

order to perform hibernation, place your monitor in front of the IR Reader as instructed in the "Getting

Started" Section. Be sure to read the device before performing hibernation to insure a connection has

been established.

Note before you perform hibernation, it is recommended that you save the event log on the monitor. To

save the log, click on the Save Event Log button. This will allow you to select a specific folder to save

the event log. Once hibernation has occurred, all prior event log information will be erased.

Once the log has been saved, you can proceed with hibernation. To hibernate the unit, press the

Hibernate button. A screen will pop up asking if you would like to save the event log. If you have

already saved the log click yes. Successful hibernation will give an OK green bar.

Issue 4 – December 2016

Page 13