Epson ActionDesk 4000 Especificaciones - Página 11

Navegue en línea o descargue pdf Especificaciones para Escritorio Epson ActionDesk 4000. Epson ActionDesk 4000 12 páginas. Product support bulletin(s)
También para Epson ActionDesk 4000: Manual de información del producto (8 páginas), Boletín de asistencia sobre productos (1 páginas)

you disable the built-in IDE hard disk drive interface by

moving jumper J35 to position 2-3. Also be sure to remove

the had disk drive ribbon connector from the system

board.

Floppy Disk Drive Problems

must enable the Password on Boot option. If you

don't enable this option, you see an error message

whenever you try to access the diskette drive.

Overheating Problems

processor has an adequate heat sink and fan installed to

prevent overheating. The Epson CPU upgrade kit comes

with a heat sink and a fan. Other manufacturer's kits may

not include these items.

Software Problems

try the installation at high speed. If this does not work

properly, select low speed by pressing the Ctrl and Alt

keys and the - key on the numeric keypad

simultaneously. Try loading the program at low speed

and then switching to high speed, if possible.

copy-protection method, try loading it at high speed. If

this does not work, load it at low speed.

Installing Option Cards

cards, option cards with an I/P connector on the back may

not fit into the option slot.

you install do not exceed the power supply limitations.

overloaded. On a system with three or more option cards,

the installation of a second hard disk drive may overload

the power supply.

support VGA, make sure you disable the built-in VGA by

changing jumpers J36 and J37 to the Off position.

COM Port Assignment

If you want to assign COM1 as COM3, you must set jumper

J6 to position 2-3. If you want to assign COM2 as COM4, you

must set jumper J7 to position 2-3.

Booting Sequence

If you cannot boot the computer from the hard disk make

sure the booting sequence in SETUP is set to

Then boot the computer from a system diskette in Drive A.

Information Reference List

Engineering Change Notices

None.

Technical Information Bulletins

None.

Product Support Bulletins

None.