Epson Equity Ie Boletín de asistencia sobre productos - Página 5
Navegue en línea o descargue pdf Boletín de asistencia sobre productos para Escritorio Epson Equity Ie. Epson Equity Ie 19 páginas. Product support bulletin(s)
También para Epson Equity Ie: Boletín de asistencia sobre productos (33 páginas), Manual de información del producto (7 páginas), Boletín de asistencia sobre productos (45 páginas), Boletín de asistencia sobre productos (21 páginas)
Imprimir página
EPSON AMERICA, INC.
Subject:
Equity Series Computers and Lotus 1 - 2 - 3 Release 3.0
Date:
12/7/89
Page:
1 of 1
The advent of Lotus 1 -
regarding memory management for the Epson Equity computers, specifically the
Equity 386/20, Equity 386SX and Equity Ile. The purpose of this document is
to discuss the memory requirements for Lotus 1 - 2 - 3 Release 3.0 and
recommendations for installation.
Because programs run significantly faster with extended memory, Lotus
recommends that you configure as
memory.
When installing Lotus 1 - 2 - 3 Release 3.0 on the Equity 386/20 or the Equity
386SX, do not use the EMS managers supplied with the system software
(EEMM386.EXE for the Equity 386/20 and EMM386.SYS for the Equity 386SX).
Neither of these EMS managers support the Virtual Control Program Interface
(VCPI) which is required for compatibility with
NOTE: Should you require an EMS manager for your Equity 386/20 or Equity
386SX, there are third party software packages available that are compatible
with Lotus 1 - 2 - 3 Release 3.0. Two such packages are 386m version 4.03
or later, and Quarterdeck Expanded Memory Manager
later.
not
Do
use VDISK with the /E switch when running Lotus on the Equity
386/20. Though Lotus Release 3.0 will load, it will overwrite any data in the
RAMDISK. VDISK supplied for both the Equity Ile and Equity 386SX is
compatible with Lotus 1 - 2 - 3 Release 3.0 and does not have a problem with
ovewriting data in the RAMDISK.
When installing Lotus 1 - 2- 3 Release 3.0 in the Equity lIe, use the EEMM286
memory manager in the hardware - emulation EMS mode. To do this, set
memory as expanded memory on the Equity lIe and do not specify the
expanded memory size.
you must select on - board memory type 5 in SETUP. When the Equity lIe
has more than 1Mb
Avoid the use of HDCACHE when installing Lotus 1 - 2 - 3 Release 3.0 on any
of the Equity computer systems discussed in this document.
INFORMATION
Product Support Bulletin
- 3 Release 3.0 has raised a number of questions
2
much
When the Equity lIe has only 1Mb system memory,
of
system memory, you
PSB No:
Originator:
memory as possible as extended
Lotus
1 - 2- 3 Release 3.0.
(QEMM)
must select
type 3, 4 or 5.
S-0108
KAS d(+#
version 4.2 or