Epson EQUITY II+ Boletín de asistencia sobre productos - Página 10
Navegue en línea o descargue pdf Boletín de asistencia sobre productos para Escritorio Epson EQUITY II+. Epson EQUITY II+ 19 páginas. 12 mhz
También para Epson EQUITY II+: Boletín de asistencia sobre productos (45 páginas), Manual del producto (12 páginas), Boletín de asistencia sobre productos (21 páginas)
Jumper 5: IRQ 12 Select
Memory Board:
Jumper 1: Built in Buffers Enable/Disable
HARD DISK DRIVES:
Q19.
What kind of hard disk drives are available for the Equity 386SX?
A.
The Equity 386SX is available in two hard disk configurations. A
40Mb 3.5" hard disk, (Conner CP- 344, 29ms access time) and a
100Mb 3.5" (Conner CP- 3104, 25ms access time) hard disk are
available.
embedded controllers with an AT interface. When installing the 40Mb
drive use type 59 and with the 100Mb drive use type 60 in SETUP.
Q20.
What hard drive controller is used in the Equity 386SX?
A.
The Equity 386SX uses a controller embedded on the hard drive.
This controller connects to a Task File Host interface that is
integrated in the system board.
Q21.
Can the Equity 386SX use other hard disk drives and controllers?
A.
Yes, the Host Interface on the system board can be disabled and
other third party hard drive controllers and drives can be used. The
interface can be disabled by setting Jumper J3 to position 1 - 2.
Other embedded controller AT- type drives can also be used with
the Host Interface.
Jumper 3: Embedded HDD Interface Enable/Disable
1 - 2: Embedded HDD Interface Disable
2 - 3: Embedded HDD Interface Enable (Factory Setting)
Jumper 4: BIOS EPROM Type
1- 2: Selects 27256 Kb ROM
2 - 3: Selects 27512 Kb ROM
1 - 2: IRQ 12 From Option Slot
2 - 3: IRQ 12 From Built - in Mouse (Factory Setting)
1 - 2: SIMM's Installed, Buffers Enabled
2- 3: SIMM's Not Installed, Buffers Disabled (Factory
Setting)
These hard disk drives offer a 1:1 interleave and use
PSB No: S-0106
Page 5 of 8