Motorola C1002 Manual del usuario - Página 34

Navegue en línea o descargue pdf Manual del usuario para Teléfono inalámbrico Motorola C1002. Motorola C1002 44 páginas. C12 series

10. Help

No dial tone

• Use only the telephone line cord supplied.

• Check that the telephone line cord is connected properly.

• Check that the mains power is connected properly and switched on.

No display

• Check that the batteries are inserted correctly and fully charged. Use only

approved rechargeable batteries supplied.

• Check that the handset is switched on. Press and hold

• Reset the base by removing the batteries and disconnecting the mains

power. Wait for around 15 seconds before connecting it again. Allow up

to one minute for the handset and base to synchronize.

icon flashes

• Handset is out of range. Move closer to the base.

• Make sure that the handset is registered to the base, see page 32.

• Check that the mains power is connected properly and switched on.

Keypad does not seem to work

• Check that the keypad lock is not on, see page 18.

icon is not scrolling during charge

• Adjust the handset slightly on the base.

• Clean the charging contacts with a cloth moistened with alcohol.

• Check that the mains power is connected properly and switched on.

• The battery is full. When the handset is fully charged,

appear steady on the display.

No Caller ID

• Check your subscription with your network operator, see page 30.

• The caller may have withheld their number.

• The record cannot be found in your phonebook. Check that you have the

correct name / number stored in your phonebook, with the full area code.

I have forgotten my PIN!

• Restore your C12 to its default settings, see "6.7 Emergency default" , page

26.

Cannot register a handset to the base

• You can register up to a maximum of 5 handsets to a C12 base. You must

de-register a handset in order to register a new one, see page 33.

• Check that you have entered the correct PIN code (default = 0000).

• Check that you are at least one metre away from other electrical

equipment to avoid interference when registering.

Help

icon will