Motorola Commercial Series Información de servicio - Página 10

Navegue en línea o descargue pdf Información de servicio para Radio Motorola Commercial Series. Motorola Commercial Series 48 páginas. Uhf2 (438-470mhz)
También para Motorola Commercial Series: Manual básico del usuario (16 páginas), Información de servicio (46 páginas), Manual del usuario (18 páginas), Manual básico del usuario (12 páginas), Información de servicio (30 páginas)

2-2

THEORY OF OPERATION

2.1

Receiver Front End

Incoming RF signals from the antenna are first routed through the harmonic filter and antenna

switch, part of the transmitter circuitry, before being applied to the receiver front end. The receiver

front end consists of a preselector filter, RF amplifier, an interstage filter, and a double-balanced first

mixer.

The preselector filter is a fixed-tuned 4-pole design using discrete elements (L1-L4 and C1-C9) in a

series/shunt resonator configuration. It has a 3 dB bandwidth of 44 MHz, an insertion loss of 2 dB

and image attenuation of 37 dB at 226 MHz, with increasing attenuation at higher frequencies.

Diode CR1 protects the RF amplifier by limiting excessive RF levels.

The output of the filter is matched to the base of RF amplifier Q21, which provides 16 dB of gain and

a noise figure of 2 dB. Operating voltage is obtained from the 5R source, which is turned off during

transmit to reduce dissipation in Q21. Current mirror Q22 maintains the operating current of Q21

constant at 6.7 mA regardless of device and temperature variations, for optimum dynamic range

and noise figure.

The output of the RF amplifier is applied to the interstage filter, a fixed-tuned 3-pole series-coupled

resonator design having a 3 dB bandwidth of 54 MHz and insertion loss of 1.8 dB. This filter has an

image rejection of 40 dB at 226 MHz, with increasing attenuation at higher frequencies.

The output of the interstage filter is connected to the passive double-balanced mixer consisting of

components T41, T42, and CR41. This mixer has a conversion loss of 7 dB. High-side injection from

the frequency synthesizer is filtered by L40-L41 and C40-C44 to remove second harmonic energy

that may degrade half-IF spurious rejection performance. The injection filter has a 3 dB bandwidth

of 52 MHz and an insertion loss of 1.5 dB. The filtered injection signal is applied to T42 at a level of

+6 dBm.

The mixer output is applied to a diplexer network (L51-L52, C51, R51) which matches the 44.85

MHz IF signal to crystal filter FL51, and terminates the mixer into 50Ω at all other frequencies.