Motorola Talkabout T62 Manual - Página 27

Navegue en línea o descargue pdf Manual para Radio Motorola Talkabout T62. Motorola Talkabout T62 31 páginas. Portable two-way radios
También para Motorola Talkabout T62: Manual del usuario (28 páginas), Manual del usuario (17 páginas)

Imprimir página

Note:

• You will see the

icon blinking on the display. This confirms that

the radio is in Easy Pairing mode waiting to receive the Channel

and Sub-Code settings from the Leader's radio. All Members'

radios will remain in this mode for 3 minutes.

• A group with many radios should have all users take this step at

the same time, so all radios can be programmed in one go.

3. On the Leader's radio, press and hold down the

until you hear a double beep.

Note:

• At the double beep, this radio's Channel and Sub-Code settings

will be transmitted, which will be received and copied by all the

other (Members') radios.

• The Leader's radio must make this transmission when all the

Members' radios are still in the Easy Pairing mode, otherwise the

transmission will not be picked up.

• On the Leader's radio, user must remember not to release the

button on the first (single) beep, otherwise this radio will become

another Member's radio. If that happens, you can press PTT to

escape, and retry the steps described in #3 again.

• If the Leader's radio is set to a channel between 9 and 16, please

ensure that all Members' radios have channels 9 to 16 activated.

• When a Member's radio with only eight Channels is being Easy-

Paired by a Leader's radio on Channel 9 or above, Easy-Pairing

will fail, indicated by three short beeps, and "Err" is displayed briefly.

Internal Voice Operated Transmission/

Voice Operated Transmission (

Transmission is initiated by speaking into the microphone of

the radio/audio accessory instead of pushing the PTT button.

L3 = High Sensitivity for quiet environments

L2 = Medium Sensitivity for most environments

L1 = Low Sensitivity for noisy environments

1. Press

Menu until the

When audio accessory is connected, the

be shown. The current setting (Off, L1–L3) will flash.

button

)

icon appears on the display.

icon will

2. Press

to select the sensitivity level.

3. Press the PTT button to exit menu or

set up.

Note: When using iVOX/VOX, there will be a short delay.

Dual Channel Monitor

Enables you to scan the current channel and another

channel alternately.

To set another channel and start Dual Channel Monitor:

1. Press

Menu until the Dual Channel Monitor

appears. The Dual Channel Monitor icon will flash.

2. Press

to select the channel then press

3. Press

to select the Sub-Code.

4. Press the PTT button or wait until time out to activate

Dual Channel Monitor. The screen will alternate between

home channel and Dual Channel Monitor channel.

5. To end Dual Channel Monitor, press

Note: If you set the same channel and Sub-Code as the current channel,

Dual Channel Monitor does not work.

Keypad Tones

You may enable or disable the keypad tones. You will hear

the key tone each time a button is pushed.

1. Press

Menu until the Keypad Tone

The current setting on/off will flash.

2. Press either

to turn on/off.

3. Press the PTT button to confirm or

set up.

Menu to continue

icon

Menu.

icon appears.

Menu to continue