Motorola JT 1000 Manual del usuario - Página 5
Navegue en línea o descargue pdf Manual del usuario para Radio portátil Motorola JT 1000. Motorola JT 1000 42 páginas. Motorola jt 1000 portable radio
Imprimir página
3
Getting Started (cont.)
Battery Installation
1.
Turn off the radio and hold it with the
back of the radio facing up.
2.
Place the two tabs of the battery
(located at the inside base of the
battery) into the metal cutouts of the
radio (located at the inside base of the
radio).
3.
Rotate the battery toward the radio and press
the top of the battery into the radio until both
battery release levers "click" into place.
Note: The battery is shipped uncharged. Batteries
must be charged before use. (See Battery Information
section.)
!
CAUTION
The disposable, non-rechargeable
alkaline battery (NTN7319) can be
used with the JT 1000 Model Only.
Battery Removal
1.
Turn off the radio and hold it such that the battery side
of the radio is tilted down.
2.
Press down on the two battery release levers.
3.
With release levers pulled down, the top of the
battery will fall away from the radio.
4.
Remove the battery from the radio.
MAEPF 22056 A
MAEPF-22057-B
MAEPF 22058 B
4
Getting Started (cont.)
Belt Clip Installation and Removal
(on Nickel-Cadmium Batteries Only)
!
CAUTION
Installation and removal of the belt
clip assembly should be done with
the battery removed from the radio
or damage could be done to the
radio housing.
Installing the Belt Clip
1.
I n s e r t a p e n c i l o r e q u i v a l e n t s i z e
instrument between the inside of the belt
clip and the metal clip assembly to hold
the metal clip partially sprung (metal clip
should be approximately parallel with the
plastic portion of the belt clip).
2.
Align the metal tabs of the belt clip with
the plastic slots of the battery housing.
3.
Slide the belt clip onto the battery,
pushing firmly until you hear a click.
4.
Remove the pencil from the clip.
Removing the Belt Clip
1.
I n s e r t a p e n c i l o r e q u i v a l e n t s i z e
instrument between the inside of the belt
clip and the metal clip assembly to hold
the metal clip partially sprung (metal clip
should be approximately parallel with the
plastic portion of the belt clip).
2.
Push the flat blade of a #2 slotted
screwdriver (or like instrument) between
the battery housing and the belt clip
release tab.
3.
While performing step 2, slide the belt
clip out and away from the battery, and
remove the screwdriver.
4.
Remove the pencil from the clip.