Motorola Verizon moto g6 Manual del usuario - Página 14
Navegue en línea o descargue pdf Manual del usuario para Auriculares Motorola Verizon moto g6. Motorola Verizon moto g6 26 páginas. Wireless bluetooth headset
También para Motorola Verizon moto g6: Manual del usuario (32 páginas), Hoja Faq (15 páginas), Manual del usuario (5 páginas)
Imprimir página
Operation
Pressure Relief Procedure
Trapped air can cause the pump to cycle
unexpectedly, which could result in serious
injury from splashing.
1. Shut off the air supply to the pump.
2. Open the dispensing valve, if used.
3. Open the fluid drain valve to relieve fluid
pressure. Have a container ready to catch
the drainage.
Flush the Pump Before First Use
The pump was tested in water. If water could
contaminate the fluid you are pumping, flush
the pump thoroughly with a compatible solvent.
See Tighten Threaded Connections, page
15.
Tighten Fasteners Before Setup
Before using the pump for the first time, check
and retorque all external fasteners. Follow
Torque Instructions, page 16. After the first
day of operation, retorque the fasteners.
14
859.0088
Starting and Adjusting the Pump
1. Be sure the pump is properly grounded.
Refer to Grounding on page 7.
2. Check fittings to be sure they are tight. Use
a compatible liquid thread sealant on male
threads. Tighten fluid inlet and outlet fittings
securely.
3. Place the suction tube (if used) in fluid to
be pumped.
NOTE: If fluid inlet pressure to the pump is
more than 25% of outlet working pressure, the
ball check valves will not close fast enough,
resulting in inefficient pump operation.
4. Place the end of the fluid hose into an
appropriate container.
5. Close the fluid drain valve.
6. Back out the air regulator knob, and open
all bleed-type master air valves.
7. If the fluid hose has a dispensing device,
hold it open.
8. Slowly increase air pressure with the air
regulator until the pump starts to cycle.
Allow the pump to cycle slowly until all air is
pushed out of the lines and the pump is
primed.