AEMC instruments L452 Manual de inicio rápido - Página 6

Navegue en línea o descargue pdf Manual de inicio rápido para Registradores de datos AEMC instruments L452. AEMC instruments L452 17 páginas.

Installing Batteries

The Model L452 can operate on two power sources:

■ USB cable connected to an external power source, such as a computer or wall plug

adapter.

■ Two internal 1.2V AA 2400mAh NiMH rechargeable batteries.

You must insert the batteries into the instrument before use, even if you plan to run the

instrument on USB power.

1. Holding the instrument firmly, slide the back cover to the right and remove it.

2. Insert the two batteries, while ensuring the positive and negative ends are

properly aligned.

3. Replace the back cover by aligning the tabs in the cover with the corresponding

slots in the instrument body and sliding the cover to the left until it locks in place.

NOTE: If the Model L452 is stored without the batteries installed, the internal clock will

need to be reset as instructed in the following section.

NOTE: Fully charge the batteries before using the instrument for best results (12hrs).

The instrument can be set up two ways:

■ DataView Data Logger Control Panel.

■ Model L452 Front Panel Interface.

Setup via the DataView

Initial setup via the Control Panel requires three steps:

■ Install DataView

■ Connect the instrument to the computer via USB cable or Bluetooth.

■ Configure the instrument's settings in the Control Panel.

Installing DataView

DataView

installations may differ slightly depending on your operating system. The

following instructions are based on a Windows 7 operating system.

1. Ensure that the USB cable is not connected to the computer. Then, insert the USB

thumb drive into an available USB port on your computer. If Autorun is enabled,

an AutoPlay window will appear on your screen. Click "Open folder to view files"

to display the DataView

Explorer to locate and open the USB drive labeled "DataView."

2. When the DataView folder is open, double-click the file Setup.exe in the root

directory.

3. The Setup screen will appear and enable you to select the language version of

the setup program. You can also select additional install options (each option is

explained in the Description field). Make your selections and click Install.

Data Logger Control Panel

and the Data Logger Control Panel on your computer.

and the Data Logger Control Panel

folder. If Autorun is not enabled or allowed, use Windows