Epson C11C501061 - Stylus Photo 900 Color Inkjet Printer Manual de información del producto - Página 9
Navegue en línea o descargue pdf Manual de información del producto para Software Epson C11C501061 - Stylus Photo 900 Color Inkjet Printer. Epson C11C501061 - Stylus Photo 900 Color Inkjet Printer 15 páginas. User manual (p.i.m plug-in)
También para Epson C11C501061 - Stylus Photo 900 Color Inkjet Printer: Especificación (2 páginas), Inicio rápido (2 páginas), Manual del usuario (12 páginas)
Imprimir página
EPSON Stylus Photo 900
6. Install the roll paper holders on the printer. Insert the left
holder into the far left slot, then insert the other holder into
the appropriate slot on the right (either the 4-inch slot as
shown, or the 8.3-inch slot further on the right).
7. Pull out approximately six inches of paper and insert it into
the sheet feeder. Then slide the left edge guide against the
paper (but not too tightly).
8. Hold the paper in place by the edges and press the
paper button until the printer feeds the paper automatically.
9. To verify that the paper is loaded straight, open the printer
cover and look into the printer.
If the paper is crooked, press the
hold it for three seconds to back the paper all the way out.
Then turn the roll paper holder knobs to roll up the paper.
Press the
roll paper button to clear the paper out error.
Repeat steps 7 through 9 to reload the paper.
EPSON Stylus Photo 900
8 -
roll
roll paper button and
5/03
Loading and Printing on Card Stock or
Matte Board
You can use the manual feed slot in the back of the printer to
print on white card stock or matte board up to 1.3 mm (0.051
inch or 51 mil) thick, in the following sizes: letter, legal, or A4
size.
Before you start, remove the paper support. Then turn the
printer on. (The printer must be on to load card stock
correctly.)
1. Push in the output tray extension, but leave the tray open.
2. Set the paper thickness lever to the
paper light begins flashing rapidly.
3. Slide the edge guide to the right to make room for the card
stock.
4. Open the printer cover and place a sheet of card stock
against the left side of the manual feed slot, with the side
you want to print on facing up.
position. The