Troubleshooting
Error Messages
The keyword does not match. Re-enter the keyword displayed on
the projector screen.
The selected projector is busy. Do you want to continue the
connection process?
EasyMP Network Projection initialization failed.
Connection failed due to keyword mismatch.
Network adapter information could not be obtained.
One or more connected projectors do not support resolutions
greater than SXGA. Reduce the screen resolution and reconnect.
One or more projectors are not responding.
Enter the keyword displayed on the projector screen.
Cannot start this application while USB Display is running.
Check the Projector Keyword displayed on the LAN standby screen, and enter the Projector Keyword.
You tried to connect to a projector that is connected to another computer.
When Yes is clicked, it connects to the projector. The connection between the projector and the other computer is cut
off.
When No is clicked, it does not connect to the projector.
The connection between the projector and the other computer is maintained.
Restart EasyMP Network Projection. If the message still appears, uninstall and then reinstall EasyMP Network
Projection.
s "Installing"
p.7
When connecting to a projector for which a Projector Keyword has been set, the wrong Projector Keyword is entered.
Check the Projector Keyword that is displayed on the LAN standby screen.
s "Operating the Computer"
p.11
Check the following point.
• Is a network adapter installed on the computer?
• Is the driver for the network adapter used installed on the computer?
• Is the network adapter enabled?
After checking, restart the computer and connect again.
If you still cannot connect, check the following.
Check the network settings on the computer and the network settings on the projector.
You can make network settings from the projector's Network menu.
See the following manual for details.
User's Guide "Network Menu (EB-1775W/EB-1770W/EB-1760W Only)"
s
There is an ELP-735 projector in the connection destination. Change the computer screen resolution to SXGA
(1280x1024) or less.
Failed to simultaneously connect to one or more of the projectors that you attempted to connect to. Check the network
settings on the computer and the network settings on the projector.
You can make network settings from the projector's Network menu.
See the following manual for details.
User's Guide "Network Menu (EB-1775W/EB-1770W/EB-1760W Only)"
s
Check the Projector Keyword displayed on the LAN standby screen, and enter the Projector Keyword.
Close USB Display and then start EasyMP Network Projection.
Remedy
43
Imprimir página