Epson Endeavor WG Boletín de asistencia sobre productos - Página 3
Navegue en línea o descargue pdf Boletín de asistencia sobre productos para Software Epson Endeavor WG. Epson Endeavor WG 17 páginas. Using with ms windows 3.x stylus 400/800+/color printer driver
También para Epson Endeavor WG: Boletín de asistencia sobre productos (15 páginas), Boletín de asistencia sobre productos (3 páginas), Manual (9 páginas)
Imprimir página
EPSON AMERICA, INC.
Product Support Bulletin
Subject: Progression/Progression 4 OS/2 2.0 Display Driver
Date: 10/08/93
Page(s): 1 of 2
This bulletin announces the availability of Wingine-enhanced 32-bit display drivers
for the Epson Progression and Progression 4 computers running IBM's OS/2 2.0.
The 32-bit Service Pack from IBM must be installed before installing the new display
drivers. Also, the current system configuration must be VGA or SVGA.
These drivers can be downloaded from the Epson Bulletin Board System (BBS) that
can be reached at (310) 782-4531. They are located in one self-extracting file
(WING_OS2.EXE) in file library DRIVERS. Once downloaded, extract the files to a
high-density diskette (1.44MB) by entering the command:
WING_OS2 A: or WING_OS2 B:
depending on which disk drive is being used. The diskette must have the volume
label OS2 DRVS.
To install a driver, place the Display Drivers diskette into drive A:. Open an OS/2
session, either full-screen or window, and enter the following command:
A:INSTALL A: C:
INSTALL.CMD on the driver diskette copies files to the hard drive and starts the
OS/2 Display Driver Install utility DSPINSTL, which prompts the user.
When the Display Driver Install main panel appears, the Primary Display should
indicate Video Graphics Array. If so, click OK and proceed. If VGA is not selected,
select Primary Display and click OK.
Highlight the Driver/Resolution desired and click OK.
When the Source Directory panel appears, choose the floppy drive ( A: ) which
contains the Driver diskette and click on Install.
When the main panel appears again, click on Cancel.
The new driver has been installed. You must shutdown and then re-boot your
system for the changes to take effect.
For any future driver changes, INSTALL.CMD on the driver diskette is not required.
PSB No: S-0166
Originator: MWT
EPSON