Epson LQ-860 - Impact Printer Boletín de asistencia sobre productos - Página 5

ESC ( C m1 m2 n1 n2 (Set Page Length in Defined Units

ml =2 and m2=0.

To determine the values for n1 and n2 perform the following steps.

Determine the desired page length in inches.

Multiply the page length by 380.

Divide the result by 256 using long division.

The remainder in the quotient from step 3 is the value for n1.

The whole number in the quotient from step 3 is the value for n2.

EXAMPLE

The page length is 8.5 inches.

8.5 x 380 = 3060

3080 divided by 258 = 11 with a remainder of 244.

In the Basic programming language, the command would look like this.

This command, as listed in the line above, will set the page length to 8.5 inches.

NOTE: The current line becomes the top of form. This command cancels any

previously set top and bottom margin settings. If you wish to set the top and bottom

margins via software command, the commands must be issued AFTER the "Set Page

Length in Defined Units" command. The proper page length setting can be confirmed

by issuing a "Form Feed" command, chr$(l2), or by pressing the "FF button on the

control panel while the printer is "Cff Line".

PSB No: P-0082

Page: 5 of 14