Ariel AM Series Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Bañeras Ariel AM Series. Ariel AM Series 10 páginas.

C-Series Whirlpool User Manual with Bluetooth

After Installation:

1. Before supplying any power to the product, you should inspect the power cables to ensure the power leads are properly connected.

2. After installation and before starting the product for the first time, you should inspection all the connections to ensure they are properly

connected; including parts, plugs, hoses, nuts, screws, wires, etc.

3. After you have fully installed the unit and made all the inspections to ensure the unit can function safely, fully clean the unit inside and out to

ensure the unit is ready for usage, and also to check for any potential lose debris that may have fallen into any of the plumbing. After a thorough

visual inspection, close the drain and fill the tub up to the overflow drain, submerging all the jets underwater. If any debris floats out, remove it. The

whirlpool system will not run unless the water-level sensor is fully submerged underwater. The water-level sensor is placed above the water line of

the water jets.

4. Turn-on the whirlpool system and operate it for a minimum of 10-minutes. Then turn-off the whirlpool system and without draining it, allow it to

sit for a minimum of 10-minutes. Now check all the plumbing, pipe works, hoses, joints, threads and any other connections for any leaks. If there are

any adjustments made, restart this test and review all the connections again.

5. You must ensure the product works as it normally would: immediately test all functions of the product to possibly find any errors. After testing,

place the tub against the wall(s) and seal the wall joints with an acid-free caulking agent and then allow it to cure sufficiently before any further use.

Important Note:

It is not generally recommended to use bath oils in whirlpool bathtubs, as the oil residue can stick to the side walls of the tub and plumbing.

The Display:

Power Standby Button

Used to turn on/off the computerized system.

Color Changing Lights Button

Used to turn on the tub light and change the brightness.

Channel Memory Button

Used to change the user-preset channels on the radio feature.

Water Jet Button

Used to turn on/off the water jet feature.

Light Brightness Button

Used to change the intensity or brightness of the tub light feature.

Parameter Setting Button

Used to change the function of a feature; used in conjunction with Volume/Parameter "UP" & "DOWN" buttons

Volume/Parameter "UP" Button

To turn up the volume or change the value of a parameter upward; used in conjunction with the "Parameter Setting" button.

Volume/Parameter "DOWN" Button

To turn down the volume or change the value of a parameter downward; used in conjunction with the "Parameter Setting" button.

Music Button

Used to turn on/off the radio feature, and also cycle between the Radio & Bluetooth functions.

Page 4 / 9