4
Insert the wireless LAN module into the port.
5
Replace the cover and secure it using the screw.
6
Plug in and turn on the projector.
7
To configure your projector for your wireless network, do one of
the following:
•
If you're using the optional Quick Wireless Connection USB key
(included with the PowerLite 1775W), insert it into the projector's
USB TypeA port, wait for the displayed message, remove the key,
and connect it to a USB port on your computer. Follow the on-screen
instructions to install the driver, then run your presentation. For
details, see the User's Guide on your projector CD.
•
If you're not using the key, continue with these steps.
8
Press the Menu button on the remote control, select the Network
menu, and press Enter.
9
Choose Network Configuration and press Enter.
10
Select the Basic menu and press Enter.
11
Select the Projector Name setting and enter a name (up to 16
characters long) to identify your projector over the network.
Use the displayed keyboard to enter characters. Press the arrow buttons
on the remote control to highlight the characters and press Enter to
select them.
Note: See the User's Guide on the projector CD for information on
adding passwords.
12
Select the Wireless LAN menu and press Enter.
13
Select the Connection Mode setting and choose one of these options:
•
Quick to connect the projector to one computer on the network
•
Advanced to connect the projector to multiple computers on
the network
14
If you selected Quick connection mode, select the Channel setting for
your wireless network and turn on the SSID Auto Setting setting.
15
Select the type of wireless network you are using as the Wireless LAN
Sys. setting.
16
If you selected Advanced connection mode, enter your network SSID (up
to 32 characters) as the SSID setting.
17
If your network assigns addresses automatically, select IP Settings and
turn on the DHCP setting. If not, turn off the DHCP setting and enter
the projector's IP Address, Subnet Mask, and Gateway Address, as
needed.
18
To prevent the SSID and IP address from appearing on the network
standby screen, set the SSID Display and/or IP Address Display settings
to Off.
19
See the next section for additional instructions.
Install network software
Install the EasyMP
®
Network Projection software on each computer that will
project over the network. Use the CD labeled Epson Projector Software for
Meeting & Presentation to install the program.
For instructions on installing and using your network software, see the EasyMP
Network Projection Operation Guide on your projector CD. This guide is
installed along with your projector User's Guide.
Imprimir página