Epson PowerLite 1825 Manual de instrucciones - Página 10

Imprimir página

Epson PowerLite 1825 Manual de instrucciones

Registering and deleting projectors for monitoring

Procedures for registration

Select the projector(s) to be registered, and then click

[Edit].

The following window will be displayed.

Make the necessary settings while referring to the following

table.

Display name Enter the name of the projector(s) to be displayed in

"Grouping view" or "Detail list view".

Up to a maximum of 32 bytes can be entered.

A space cannot be used as the first character.

Display icon

Select the icon(s) to be displayed in "Grouping view"

or "Detail list view".

Parent group

Select when registering a projector in a group.

If no groups have been created, this cannot be

selected. s"Registering several projectors to a

monitoring group all at once"

Projectors that have been registered using automatic search are

searched for again by projector name each time EMP Monitor is

started.

p.13

Projector

This shows the name that has been registered on the

name

projector.

IP address

This shows the IP address for the registered projector.

Use Serial ⇔

This cannot be selected when registering projectors

TCP/IP

using automatic search.

conversion

adaptor.

Port Number

This cannot be selected when registering projectors

using automatic search.

Monitor

If a Monitor Password has been set for the projector,

Password

be sure to enter the Monitor Password that has been

set. If the correct password is not entered at this time,

it will not be possible to monitor and control the

projector even though it is registered.

Description

You can enter some kind of memo about the projector.

The details you enter here will be displayed at the

projector properties.

Up to a maximum of 60 bytes can be entered.

Monitor

Select this when you want monitoring to start.

After entering the details, click [Register] to start the

registration. When the message is displayed, click

[OK].

To continue registering other projector(s), repeat Steps 3 and 4.

TIP