Epson PowerLite 765c Manual de piezas - Página 14

Imprimir página

Epson PowerLite 755c/765c Projector

Access point mode: On the General tab, select

, then click the

Protocol

screen:

9. If your access point uses DHCP, select

. Otherwise, select

automatically

and enter the required information.

address

: Type in the IP address you want to assign to

IP address

the computer. It must be formatted like other addresses

on the network; usually the first three sections

(XXX.XXX.XXX) match the access point's IP address,

and the last section is unique.

: For example, 255.255.255.000, but this

Subnet mask

too must match how your network is set up.

: Enter the IP address that was assigned

Default gateway

to the access point when it was set up.

10.When done, click

11.Click the

Wireless Networks

Epson PowerLite 755c/765c Projector

Internet

button. You see this

Properties

Obtain IP address

Use the following IP

tab. You see this screen:

Note:

If you don't see this tab, you may need to enable your wireless

card or network device by clicking

device settings; then follow any instructions on the screen to

enable the device.

12.Verify that you've enabled your computer's connection to

the access point. It should be listed as shown above, with the

small icon

next to it, indicating a connection.

If it's not listed, click

your access point.

13.When you're done, click

Wirelessly" on page 15.

Checking the Gateway (Access Point's) IP Address

If you're entering IP addresses manually in access point mode

and need to find out the gateway IP address (the IP address of

your access point), make sure the wireless connection to the

access point is currently active, as described in the previous

section.

Note:

If you can't identify the gateway address using this Windows utility,

use the administrator's utility software that came with your access

point.

1. Access your wireless network Properties window. For

example, in Windows XP click

Network and Internet Connections

double-click the

Network Connections

2. Right-click the

Wireless Network Connection

select

. Then click the

Status

The gateway's (access point's) IP address is listed as shown:

8/05

to access the

Configure

and then type the name of

Configure

. Continue with "Projecting

Start > Control Panel >

. Then

icon.

tab.

Support

Gateway

address

icon and