Epson PowerLite 765c Manual de piezas - Página 4

Imprimir página

Epson PowerLite 755c/765c Projector

3. Press the P

button on top of the projector or on the

Power

remote control.

Projector

The projector beeps once and the

as the projector warms up, then an image begins to appear.

When the

light stops flashing and remains green, the

Power

projector is ready for use.

Warning:

Never look into the lens when the lamp is on. This can damage

your eyes, and is especially dangerous for children.

If you've connected a Windows

projector, you may see a New Hardware Wizard saying

your computer has found a plug-and-play monitor; if so,

click

Cancel

If you don't see the image you want, press the

button on the projector or the

the remote control until you see the image you want to

project.

If you are prompted to enter a password, see "Starting the

Projector with a Password" on page 10.

Note:

You can also use the Source buttons on the remote control to

switch between devices connected to the ports identified on each

button. For details, see page 5.

If a projected image fails to appear, see "You Can't Project an

Image" in the next column.

When you're done with your presentation, shut down the

projector as described on page 7. Shutting down the projector

correctly prevents premature lamp failure and possible damage

from overheating.

Epson PowerLite 755c/765c Projector

Power button

Remote control

light flashes green

Power

-based computer to the

Source

button on

You Can't Project an Image

If you don't see the image you are trying to project, try the

following:

Make sure the cables are connected correctly.

Make sure the

Power

lens cap is off.

If you've connected more than one computer and/or video

source, you may need to press the

the projector's control panel or

remote control to select the correct source. (Allow a few

seconds for the projector to sync up after pressing the

button.)

If you're using a PC notebook, see below.

The Projector and Notebook Don't

Display the Same Image

If you're projecting from a notebook, and you can't see your

image on the projection screen and on your computer at the

same time, follow these guidelines.

If you're using a PC notebook:

On most systems, there's a function key that lets you toggle

between the LCD screen and the projector, or display on

both at the same time. It may be labeled

an icon such as

key while pressing it. Allow a few seconds for the projector to

sync up after changing the setting.

If the function key doesn't permit you to display

simultaneously on both screens, you should check your

monitor settings to make sure both the LCD screen and the

external monitor port are enabled.

From the Control Panel, open the

Display Properties dialog box, click the

click

. The method for adjusting the settings

Advanced

varies by brand; you may need to click a

make sure the external Monitor port is set as your primary

display and/or enabled. See your computer's documentation

or online help for details.

8/05

light is green and not flashing and the

Source Search

button on the

CRT/LCD

. You may have to hold down the

utility. In the

Display

Settings

Monitor

button on

or have

tab, then