Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine Manual de montaje y puesta en marcha - Página 10

Navegue en línea o descargue pdf Manual de montaje y puesta en marcha para Software Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine. Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine 14 páginas. Product support bulletin
También para Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine: Folleto y especificaciones (8 páginas), Hoja de especificaciones (8 páginas), Manual de instalación rápida (34 páginas), Información sobre el producto (17 páginas), Referencia rápida (10 páginas), Especificaciones (4 páginas), Boletín de asistencia sobre productos (44 páginas)

Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine Manual de montaje y puesta en marcha
5. Fit the left end of the spindle into the left
mounting bracket inside the printer.
6. Make sure that the printer is turned on, then
repeatedly press the Paper Source button
until the Roll Auto Cut light comes on.
7. Set the paper lever to the released position.
Note:
For the position names of the paper lever, see the
attached instruction seal on the lever shown below.
8
8. Insert the paper into the paper insertion slot.
9. Pull the paper down through the paper
insertion slot so that it comes out below.
Note:
If the roll paper does not come out, adjust the
feed strength by pressing the Paper Feed
buttons on the control panel. When using
thick, heavy, or curled paper, press the Paper
Feed (+) button to increase the power. When
using thin or light paper, press the Paper
Feed (-) button to decrease the power.
If the paper does not come out even after
executing the procedure above, open the front
cover and pull the paper out manually.