Philips AZ102C Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Sistema estéreo Philips AZ102C. Philips AZ102C 15 páginas. Cd soundmachine
También para Philips AZ102C: Especificaciones (2 páginas), Manual del usuario (15 páginas), Manual del usuario (14 páginas), Especificaciones (2 páginas), Manual del usuario (2 páginas), Manual del usuario (2 páginas), Manual del usuario (2 páginas), Manual del usuario (18 páginas), Manual del usuario (13 páginas), Especificaciones (2 páginas), Manual del usuario (1 páginas), Manual de servicio (11 páginas)

Imprimir página

Power Supply

Using AC power

WARNING: Always check you have

completely switched off the set, before

you change or disconnect power supply.

1 Check if the power voltage, as shown on

the type plate located on the bottom

of the set, corresponds to your local power

supply. If it does not, consult your dealer or

service center.

2 Connect the power cord to the AC

MAINS~ inlet and the wall socket.The set is

now connected and ready for use.

3 To switch the set off completely, withdraw the

power cord from the wall socket.

4 Install the unit near the AC outlet and where

the AC power plug can be easily reached.

Disconnect the power cord from the wall

socket to protect your set during heavy

thunderstorms. Children could seriously injure

themselves as the free end of the cable may

still be live if only the connector is removed

from the MAINS socket at the back of the

unit.

The type plate is located on the bottom

of the set.

Helpful hints:

–

Source selector

STANDBY

General Operation / Tuner

General operation

Switching on and off and selecting the

function

1 To select your sound source, adjust the

Source selector to: CD, FM or MW.

2 To switch off the set, adjust the Source

selector to STANDBY position.

3 To switch to LINE IN mode, connect an

external audio source to the LINE-IN inlet.

Helpful hints:

The set switches to LINE IN mode

automatically when an external audio source

is connected, no matter the set is in CD, FM

or MW mode.

The LINE-IN inlet is not for earphones.

Adjusting volume and sound

Adjust the sound with the VOLUME and

DBB controls.

Radio reception

1 Adjust the Source selector to FM or

MW.

2 Turn TUNING to tune to a station.

Helpful hints:

To improve radio reception

For FM, extend, incline and turn the

telescopic antenna for best reception. Reduce

its length if the signal is too strong.

For MW, the set uses a built-in antenna.

Direct this antenna for best reception by

turning the whole set.