Croydex MM710400E Manual - Página 2

Navegue en línea o descargue pdf Manual para Mobiliario interior Croydex MM710400E. Croydex MM710400E 7 páginas.

Fixing Pack Contents

Hang'N'Lock Wall Mounting Bracket Kit x1, 'L' Shape Bracket Mounting Kit x1.

Tools Required

Drill; 8mm masonry drill bit (8mm ceramic drill bit optional); Cross head screwdriver; Flat head

screwdriver; Pencil; Spirit level

KEEP DIY TOOLS OUT OF THE REACH OF CHILDREN

Home Safety Advice

It is recommended that two people fit the mirror to ensure that it is fitted safely.

Always take care when using an electric drill, particularly in the bathroom. Always check for hidden

cables and pipe work before drilling and take extreme care if there is any water in the working area.

It is advisable to use a residual current circuit breaker (RCCB).

Always wear suitable eye protection when drilling.

If the mirror is to be fitted on a ceramic tiled wall, a ceramic drill bit should be used. Always ensure

that the drill hole passes through the central tiled area rather than through the grouted area. To

prevent unnecessary damage to the tile, mask the area around the hole with tape before drilling.

Do not strike the mirror with hard or sharp

objects.

Fixing Instructions

Positioning the Mirror

1. The mirror is rated IP44 and must only be

installed with the connection to the domestic

mains electrical supply in the Outside Zones, as

shown in Figure 1.

2. Ensure that the access to the domestic mains

electrical supply is located behind the intended

mounting position for the mirror and unobstructed

by the mounting brackets.

Mounting using Hang 'N' Lock

1. Assemble the Hang 'N' Lock bracket sections making sure all parts

are slotted tightly together.

2. Place the assembled Hang 'N' Lock bracket onto the support slot

on the back of the mirror and hold in place. Measure the distance

from the bottom edge of the bracket to the top edge of the mirror

glass. Make a note of the 'Bracket Distance' as it will help you when

mounting your mirror.

Carefully hold your mirror in the desired location on the wall and

using a pencil draw a reference line along the top edge of the mirror.

Use the Bracket Distance you measured earlier to create a reference

line where the bottom of your Hang 'N' Lock bracket will be located.

Fig 1

Images for reference only.

MIR 035 R02