Croydex Beaulieu WC410122E Manual - Página 3

Navegue en línea o descargue pdf Manual para Productos de fontanería Croydex Beaulieu WC410122E. Croydex Beaulieu WC410122E 7 páginas. Vanity unit, mirror and light

Imprimir página

Hang 'N' Lock fixing components - Vanity Unit

A. Hang 'N' Lock

Bracket x 1

E. Hang 'N' Lock

F. Countersink Fixing

Locking Stud x 2

Screws x 2 (Optional)

Hang 'N' Lock fixing components - Mirror

A. Hang 'N' Lock

Bracket x 1

D. Hang 'N' Lock

E. Countersink Fixing

Locking Stud x 2

Screws x 2 (Optional)

Vanity Unit Installation

Marked Screw Position

Place the bottom edge of the

Hang 'N' Lock bracket onto the

reference line and using a pencil,

mark the screw hole positions in each

cam recess. Remove the Hang 'N' Lock

bracket from the wall surface prior to

drilling.

C. Hang 'N' Lock Spacer

B. Hang 'N' Lock

Bracket x 1

(Small)

H. Wall Plugs x 2

G. Fixing Screws x 2

(Optional)

C. Hang 'N' Lock

B. Hang 'N' Lock

Bracket x 1

Cam x 2

G. Wall Plugs x 2

F. Fixing Screws x 2

(Optional)

Top edge of Vanity Unit

'A'

Bottom edge of Hang 'N' Lock bracket

Drill the marked holes to a depth of 45mm.

Insert the wall plugs level with the surface

of the wall. (Note: if you are fitting the

product to a tiled surface, insert the wall

plugs below the surface of the tile to avoid

cracking, the tile) Insert 2 x screws (Either

countersink or standard screws can be

used) through the Hang 'N' Lock cams and

loosely secure the Hang 'N' Lock bracket

to the wall.

4 screws are supplied within this

fixing pack.

D. Hang 'N' Lock

Only 2 x screws are required to

Cam x 2

install the Hang 'N' Lock bracket.

Please use either the countesink or

dome head fixing screws supplied.

4 screws are supplied within this

fixing pack.

Only 2 x screws are required to

install the Hang 'N' Lock bracket.

Please use either the countesink or

dome head fixing screws supplied.

Assemble the Hang 'N' Lock bracket sections

making sure all parts are slotted together tightly.

Place the Hang 'N' Lock bracket onto the

hanging baton at the back of the Vanity Unit and

measure the dimension 'A' – See fig.1.

Determine the desired location of the Vanity Unit

and mark a point at the top edge of the cabinet

on the wall surface. Using dimension 'A' draw a

horizontal reference line below the top mark to

determine the position of the bottom edge of the

Hang 'N' Lock bracket.

With the Hang 'N' Lock bracket loosely

attached to the wall, adjust for height

and level by rotating the cams with

a flat head screwdriver aligning the

bottom edge of the HNL bracket with

the reference line, then fully tighten the

mounting screws using a philips

screwdriver, to securely fix the bracket

into position. Adjust for level if required.

CAB 100 R01