Aeon AEOTEC GEN5 Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Accesorios Aeon AEOTEC GEN5. Aeon AEOTEC GEN5 8 páginas. Door window sensor

23-2-2017

Removing your Sensor from your Z-Wave Network.

Your sensor can be removed from your Z-Wave network at any time. You'll need to use your Z-Wave network's main

controller/gateway. To do this, please refer to the part of their respective manuals that tell you how to remove devices

from your network.

1. Put your primary controller into device removal mode.

2. Unlock your Sensor from the Back Mount plate and take the Sensor unit near to your primary controller.

3. Press the Action Button on your Sensor.

4. If your Door Window Sensor has been successfully removed from your Z-Wave network, its Status LED will fast

blink for 8 seconds and then slow blink for 3 seconds when you press the Action Button again. If the removing was

unsuccessful, the Status LED will fast blink for 2 seconds and then be solid for 2 seconds when you press the

Action Button, repeat the above steps.

Include Sensor as a non-secure device.

If you want your Sensor as a non-security device in your Z-wave network, you just need to press the Action Button once

on Door Window Sensor when you use a controller/gateway to add/include your Sensor.

Include Sensor as a secure device.

In order to take full advantage of all functionality the Door Window Sensor, you may want your Sensor is a security device

that uses secure/encrypted message to communicate in Z-wave network, so a security enabled controller/gateway is

needed for the Door Window Sensor to be used as a security device.

To do this, press the Sensor's Action Button 2 times within 1 second when your security controller/gateway starts the

network inclusion.

Factory Reset Sensor.

If your primary controller is missing or inoperable, you may wish to reset all of your Door Window Sensor's settings to their

factory defaults.

To do this, press and hold the Action Button for 20 seconds and Status LED will be solid for 2 seconds to conﬁrm a

success.

Technical specifications.

Model number: ZW120.

Battery: Up to 1 year battery life with 2×AAA batteries.

Operating temperature: 0°C to 40°C.

Relative humidity: 8% to 80%.

Operating distance: Up to 300 feet/100 metres outdoors.

https://aeotec.freshdesk.com/support/solutions/articles/6000159782-door-window-sensor-gen5-user-guide-

Door Window Sensor Gen5 (User Guide) : Aeotec by Aeon Labs

7/8