Dimplex DS5629 Manual de servicio - Página 8

Navegue en línea o descargue pdf Manual de servicio para Estufa Dimplex DS5629. Dimplex DS5629 12 páginas. Dimplex stove service manual
También para Dimplex DS5629: Manual práctico del usuario (11 páginas), Manual del usuario (14 páginas), Manual del usuario (14 páginas), Manual de servicio (12 páginas)

Imprimir página
Dimplex DS5629 Manual de servicio
front of the emberbed and remove the grate from the
unit.
3.
Remove the logset from the unit by pulling forward and
lifting out.
4.
Remove the reflector rod from the flame motor by pull-
ing the end of the rod to the left and carefully remove
flame rod from rubber sleeve.
5.
Reassemble in the reverse order as above.

FLICKER MOTOR REPLACEMENT

WARNINg: If the stove was operating prior to servic-
ing, allow at least 10 minutes for light bulbs and heating
elements to cool off to avoid accidental burning of skin.
WARNINg: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1.
Remove the thermostat knob.
2.
Gently place stove on it's back on a flat surface.
3.
Remove the heater cover retaining screws located on
the bottom of the stove and lower heater/light assembly
onto the floor.
4.
Remove the reflector rod and motor assembly by
removing the screws on the front and rear of the heater
cover.
5.
Remove the heater retaining screws form the bottom of
the heater cover.
6.
Disconnect the wiring clips and connections noting their
original locations.
7.
Reassemble in the reverse order as above.
Figure 6
8
Figure 7
REMOTE CONTROL RECEIVER
REPLACEMENT
WARNINg: If the stove was operating prior to servic-
ing, allow at least 10 minutes for light bulbs and heating
elements to cool off to avoid accidental burning of skin.
WARNINg: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1.
Open door by pulling the handles.
2.
Loosen the 2 retainers on the inner sides of the unit by
turning counter clockwise.
3.
Remove 4 screws that secure the top on the rear of the
unit.
4.
Lift the top off of the unit. Carefully remove the partially
reflective glass and store in a safe place to prevent
damage.
5.
Locate the remote control receiver on the wall of the
unit.
6.
Remove wiring connections from the receiver noting
their original locations.
7.
From inside the unit, break off the 4 mounting studs
by grasping with pliers and twisting on the protruding
part of the stud, push the remainder of the studs out
through the top panel.
!
NOTE: New mounting studs are supplied with the re-
placement remote control receiver.
8.
Reassemble in the reverse order as above.

CONTROLS REPLACEMENT

WARNINg: If the stove was operating prior to servic-
ing, allow at least 10 minutes for light bulbs and heating
elements to cool off to avoid accidental burning of skin.
WARNINg: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
www.dimplex.com