Dimplex DS7425DLX Manual de servicio - Página 4

Navegue en línea o descargue pdf Manual de servicio para Estufa Dimplex DS7425DLX. Dimplex DS7425DLX 12 páginas.
También para Dimplex DS7425DLX: Manual de servicio (12 páginas), Manual del usuario (14 páginas)

Imprimir página

OPERATION - DS7420 MOD A - D

To access the controls, go to the back of the stove. (Figure

A. MAIN ON/OFF SWITCH

The Main On/Off switch supplies power to all stove func-

tions (heater & flame).

B. TOP LIgHT ON/OFF SWITCH

Controls the light intensity of the log bed display area.

C. HEATER ON/OFF SWITCH

The Heater On/Off switch supplies power to the heater.

D. HEATER THERMOSTAT

To adjust the temperature to your individual requirements,

turn the thermostat clockwise all the way to turn on the

heater. When the room reaches the desired temperature,

turn the thermostat knob counter clockwise until you hear a

click. Leave in this position to maintain the room tempera-

ture at this setting. For additional heat, turn clockwise until

you hear the click again and the heater will turn on.

RESETTINg THE TEMPERATURE CUTOFF SWITCH

Should the heater overheat, an automatic cut out will turn

the heater off and it will not come back on without be-

ing reset. It can be reset by switching the MAIN ON/OFF

SWITCH to OFF and waiting 5 minutes before switching

the unit back on.

CAUTION: If you need to continuously reset the heater,

unplug the unit and call Dimplex North America Limited

at 1-800-668-6663.

Figure 3

REMOTE CONTROL

The remote control has a range of approximately 50ft.

(15.25m) it does not have to be pointed at the stove and

can pass through most obstacles (including walls). It is

supplied with one of 243 independent frequencies to pre-

vent interference with other units. The frequency designa-

tion is indicated on the back of the Remote Control (Figure

REMOTE CONTROL INSTALLATION

Plug stove power cord into the outlet located on the

side of the receiver. (Figure 4)

Plug receiver into the wall outlet.

Install a 9 volt battery into the Remote Control (Figure

4).

! NOTE:

•

Stove Main On/Off switch must be in the ON position

prior to using the Remote Control.

•

ON/OFF Remote Control may be used to control most

other electrical devices including T.v.'s, stereos and

lamps.

CAUTION:

•

For indoor use in dry areas only

•

For use on electrical devices with 15 amp resistive load

or 1/3 HP inductive load

•

120 volt AC only

Figure 4

OPEN

Receiver

Outlet

OPEN

Frequency

Code

Battery

Cover