Dimplex RIT20 Manual de instrucciones - Página 2

Navegue en línea o descargue pdf Manual de instrucciones para Estufa Dimplex RIT20. Dimplex RIT20 3 páginas. Brayford log stove; springborne coal stove
También para Dimplex RIT20: Instrucciones de instalación y funcionamiento (2 páginas), Instrucciones de instalación y funcionamiento (2 páginas), Instrucciones (4 páginas)

Imprimir página

- Club Stove, CLB20 -Courchevel Stove, CVL20

- Ritz Stove, RIT20

IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE

Important Safety Advice

When using electrical appliances, basic precautions

should be followed to reduce the risk of fire, electric

shock, and injury to persons, including the following:

If the appliance is damaged, check immediately with

the supplier before installation and operation.

Do not use this appliance in the immediate surround-

ings of a bath, shower or swimming pool.

Do not use outdoors.

This appliance must not be located immediately

above or below a fixed socket outlet or connection

box.

WARNING : The appliance carries the

Warning Symbol indicating that it must not be

covered or has a Do not cover label. Do not

cover or obstruct in any way the heat outlet

grille located underneath the appliance Overheating

will result if the appliance is accidentally covered. Do

not place material or garments on the appliance, or

obstruct the air circulation around the appliance, for

instance by curtains or furniturne, as this could cause

overheating and a fire risk.

In the event of a fault unplug the heater.Unplug the

appliance when not required for long periods.The

supply cord must be placed on the right hand side of

the heater away from the heat outlet underneath the

appliance.

Although this appliance complies with safety stand-

ards, we do not recommend its use on deep pile

carpets or on long hair type of rugs.

This appliance can be used by children aged form 8

years and above and persons with reduced physical,

sensory or mental capabilities or lack of experinence

and knowledge if they have been given supervision or

instruction concerning use of the appliance in a safe

way and understand the hazards involved. Children

shall not play with the appliance. Cleaning and user

maintaince shall not be made by Children without

supervision.

Children of less than 3 years should be kept away

unless continuously supervised. Children aged from

3 years and less than 8 years shall only switch on/

off the appliance provided that it has been placed or

installed in its intended normal operating position and

they have been given supervision or instruction con-

cerning use of the appliance in a safe way and under-

standing the hazards involved. Children aged from 3

years and less than 8 years shall not plug in, regulate

and clan the appliance or perform user maintaince.

The appliance must be positioned so that the plug is

accessible.

If the supply cord is damaged it must be replaced by

the manufacturer or service agent or similarly quali-

fied person in order to avoid a hazard.

CAUTION: In order to avoid a hazard due to

inadvertent resetting of the thermal cut-out, this

appliance must not be supplied through an external

switching device, such as a timer, or connected to a

AUS

circuit that is regularly switched on and off by the

utility.

This appliance is not equipped with a device to

control the room. Do not use this heater in small

rooms when they are occupied by persons not

capable of leaving the room on their own, unless

constant supervision is provided.

The appliance must not to be located beneath a

socket outlet.

CAUTION - Some parts of this product can become

very hot and cause burns. Particular attention has

to be given where children and vulnerable people

are present.

General

Unpack the heater carefully and retain the packaging for possible

future use, in the event of moving or returning the fire to your supplier.

These models are designed to be free standing and are normally

positioned against a wall.

The fire incorporates a flame effect, which can be used with or without

heating, so that the comforting effect may be enjoyed at any time of

the year. Using the flame effect on its own only requires little electricity.

A choice of 1kW or 2kW heat output is provided by the fan heater,

which is located at the bottom of the unit.

Before connecting the heater check that the supply voltage is the same

as that stated on the heater.

Please note: Used in an environment where background noise is

very low, it may be possible to hear a sound which is related to the

operation of the flame effect. This is normal and should not be a

cause for concern.

Electrical connection

WARNING – THIS APPLIANCE MUST BE EARTHED.

This heater must be used on an AC ~ supply only and the voltage

marked on the heater must correspond to the supply voltage.

Before switching on, please read the safety warnings and operating

instructions.

Controls - see Fig. 2

These switches provide a choice of heat settings, The appliance

is in standby mode when the mainslead is plugged in. This

is indicated by the red neon behind the flame effect screen.

The two selector switches are in the ON position when the side with

the markings on (i.e. I, or II) is pushed in.

Selector switch 1 (0) Controls the electricity supply to the

appliance and flame effect. Press for 'ON'

and 'Standby'. If both selector switches 2 and

3 are in the OFF position, the product works

on flame effect only.

Selector Switch 2 (I) Provides 1kW heat output

Selector Switch 3 (II) Provides 2kW output with switch 2

Remote control - see Fig. 6

The maximum range of use is ~ 6metres.

Warning: It takes time for the receiver to respond to the transmitter.

Do not press the buttons more than once within two seconds for

correct operation.

Battery information - see Fig. 6

Slide open the battery cover on the back of the remote

control

Install AAA batteries into the remote control

Replace the battery cover.

Discard leaking batteries

Dispose of batteries in the proper manner according to provincial and

local regulations.

Any battery may leak electrolyte if mixed with a different battery type,

if inserted incorrectly, if all the batteries are not replaced at the same

time, if disposed of in a fire, or if an attempt is made to charge a battery

not intended to be recharged.