Dimplex Danube DNB20 Instrucciones de instalación y funcionamiento - Página 2
Navegue en línea o descargue pdf Instrucciones de instalación y funcionamiento para Calentador eléctrico Dimplex Danube DNB20. Dimplex Danube DNB20 2 páginas. Dimplex installation and operating instructions portastove dnb20, lag20, elb20
También para Dimplex Danube DNB20: Instrucciones de instalación y funcionamiento (2 páginas)
Imprimir página
Switch 1 ( I ) Controls the electricity supply to the heater and
flame effect
Note: This switch must be in the ON ( I ) position
for heater to operate with or without heat
Switch 2 ( I ) Provides 1kW heat output
Switch 3 ( II ) Provides 2kW output with switch 2
Maintenance
WARNING – BEFORE UNDERTAKING ANY MAINTENANCE OR
CLEANING REMOVE PLUG OR DISCONNECT FROM THE
ELECTRICITY SUPPLY.
Lamp Replacement
four screws on
removable back
panel
Two lamps are located behind the back panel as indicated in Fig. 3.
To gain access to the lamps, the four screws which secure the back
panel, must be removed. Remove and slide out panel as indicated in
Fig. 4.
The product complies with the Australian/New Zealand Safety Standards AS/NZ S 335.2.30:1997 and 2002 Part 1 also the European Standard ElectromagneticCompatibility (EMC) EN 55 014-
1:1993, EN 61000-3-2:1995, EN 61000-3-3:1995, EN 55 014-2:1997. These cover the essential requirements of EEC Directive 2006/95/EC and 2004/108/EC.
Specification subject to change without prior notice
Remove the defective lamp by unscrewing it as shown -see Fig. 5.
Replace with a 60W E14 SES Clear Candle lamp.
Take care not to over-tighten the lamp. Refit the back panel and
secure with the four screws.
Thermal Safety Cut-out
The built-in overheat cut-out switches of the appliance automatically
in the event of a fault. Switch off the appliance or disconnect the
mains plug from the socket. After a short cooling down phase, the
appliance is ready for use again. If the fault should occur again, see
your local dealer.
WARNING: In order to avoid a hazard due to inadvertent resetting of
the thermal cut-out, this appliance must not be supplied through an
external switching device, such as a timer, or connected to a circuit
that is regularly switched on and off by the utility.
Cleaning
For general cleaning use a soft clean duster – never use abrasive
cleaners. The viewing screen should be cleaned carefully with a
soft cloth. DO NOT use proprietary glass cleaners.
After Sales Service
Please see the separate Warranty leaflet for details of your
Fig. 3
Warrantee & after sales service including contact details.
Should you require after sales service, please get in touch with
the supplier through whom you purchased the appliance, or the
contact number on your Warranty leaflet.
Fig. 4
Fig. 5