Crutchfield 575PM500X2 Manual de configuración rápida - Página 2
Navegue en línea o descargue pdf Manual de configuración rápida para Amplificador Crutchfield 575PM500X2. Crutchfield 575PM500X2 9 páginas.
Imprimir página
Input Clip Indicator Setup
Be sure to disconnect all speakers from
the amplifier.
.6CAUTION
Failure to comply may cause damage to
connected components and/or
amplifier.
Increase the source unit volume until the
Input Clip Indicator illuminates red.
Note: Input Clip can be viewed remotely
with optional PLC2.
Decrease the source unit volume slightly
until the light turns completely
off.
This
establishes your maximum source unit
volume for adjusting the Output Clip
Indicator.
Note: Some source units will not clip.
Amplifier Clip Indicator Setup
Insert test tone or music CD to play for setup
.
Adjust the Bass & Treble levels on the source
unit to flat.
Be sure to disconnect Punch
Level Control - PLC (if
equipped) from the amplifier.
Note: Use the 40Hz@ OdB tone (Track 5) for
mono amplifier applications or the 1kHz@ OdB
tone (Track 7) for multi-channel amplifier
applications. Be sure your x-over is switched to
the appropriate filter setting.
Output Clip Indicator
Setup
Turn the source unit volume
down.
MUSIC TESTTONE
'
BLUE
~
. /
~r=======l
BLUE/REO
. /
~
~
......... ;;;;;;;;;;;;;;; ...........................
--!
RED
A
~
~.
0 .
.2.0
P L J N C : : : H
/ i \
(l)
12.0'
·0.15
INPUTLEVR
v
Adjust the Input Level knob
until the Output Clip Indicator
illuminates to the appropriate
color. Repeat for all channel
levels of input.
Reconnect all speakers and
Punch Level Control - PLC (if
F:::::::::::::::~==l
equipped) to the amplifier. Be
sure to maintain proper
~
speaker
polarity.
V
11111111
--~~~~-------------------------------~