Pioneer AppRadio SPH-DA01 Manual de instrucciones - Página 26
Navegue en línea o descargue pdf Manual de instrucciones para Receptor para automóvil Pioneer AppRadio SPH-DA01. Pioneer AppRadio SPH-DA01 32 páginas. Display unit appradio
También para Pioneer AppRadio SPH-DA01: Manual de instrucciones (36 páginas), Información importante para el usuario (24 páginas), Manual de instalación (40 páginas), Actualizaciones de firmware (4 páginas)
Imprimir página
Appendix
Appendix
Troubleshooting
If you have problems operating this product, refer to this section. The most common problems are
listed below, along with likely causes and solutions. If a solution to your problem cannot be found
here, contact your dealer or the nearest authorised Pioneer service facility.
Problems with this product
Symptom
The power doesn't turn on. This
product doesn't operate.
The screen is too bright.
The display is very dim.
No sounds of audio source are
produced.
The volume level will not rise.
The person on the other end of
the phone call cannot hear the
conversation due to an echo.
There's no picture.
Nothing is displayed and the
touch panel keys cannot be
used.
Problems in the audio screen
Symptom
iPhone cannot be operated.
26
Engb
Cause
Leads and connectors are incor-
rectly connected.
The fuse is blown.
Noise and other factors are causing
the built-in microprocessor to oper-
ate incorrectly.
Picture quality adjustment of the
display is not correct.
The vehicle's light is turned ON, and
"Dimmer" is selected on "ON".
Picture quality adjustment of the
display is not correct.
The volume level is low.
The mute is on.
A speaker lead is disconnected.
The voice from the person on the
other end of the phone call is output
from the speakers and then picked
up by the microphone again, creat-
ing an echo.
The handbrake cord is not con-
nected.
The handbrake is not applied.
The backlight of the LCD panel is
turned off.
The setting for the rear view camera
is incorrect.
The gearstick was placed in [R]
when the rear view camera was not
connected.
Cause
The iPhone is frozen.
An error has occurred.
Action (Reference)
Confirm once more that all connections are
correct.
Rectify the reason for the fuse blowing, then
replace the fuse. Be very sure to install a cor-
rect fuse with the same rating.
Press the Reset button.
Adjust the picture quality. (Page 21)
Set "Dimmer" to "OFF". (Page 21)
Adjust the picture quality. (Page 21)
Adjust the volume level.
Turn the mute off.
Check the connection.
Use the following methods to reduce the
echo:
—Lower the volume on the receiver
—Have both parties pause slightly before
speaking
Connect the handbrake cord, and apply the
handbrake.
Connect the handbrake cord, and apply the
handbrake.
Turn on the backlight. (Page 21)
Select the appropriate setting for the rear
view camera.
Select the correct polarity setting for "Rear
Camera". (Page 21)
Action (Reference)
Reconnect the iPhone with the iPhone cable.
! Reconnect the iPhone with the iPhone
cable.
! Press the Reset button.