Pioneer AVG-VDP1 Manual de instalación - Página 10

Navegue en línea o descargue pdf Manual de instalación para Receptor para automóvil Pioneer AVG-VDP1. Pioneer AVG-VDP1 30 páginas. Vehicle dynamics processor
También para Pioneer AVG-VDP1: Manual (39 páginas)

Imprimir página

Installation

Note:

• Before making a final installation of the unit,

temporarily connect the wiring to confirm that the

connections are correct and the system works

properly.

• Use only the parts included with the unit to

ensure proper installation. The use of unautho-

rized parts can cause malfunctions.

• Consult with your nearest dealer if installation

requires the drilling of holes or other modifica-

tions of the vehicle.

• Install the unit where it does not get in the dri-

ver's way and cannot injure the passenger if there

is a sudden stop, like an emergency stop.

• When mounting this unit, make sure none of the

leads are trapped between this unit and the sur-

rounding metalwork or fittings.

• Do not mount this unit near the heater outlet,

where it would be affected by heat, or near the

doors, where rainwater might splash onto it.

• Before drilling any mounting holes always check

behind where you want to drill the holes. Do not

drill into the gas line, brake line, electrical wiring

or other important parts.

• If this unit is installed in the passenger compart-

ment, anchor it securely so it does not break free

while the car is moving, and cause injury or an

accident.

• If this unit is installed under a front seat, make

sure it does not obstruct seat movement. Route all

leads and cords carefully around the sliding

mechanism so they do not get caught or pinched

in the mechanism and cause a short circuit.

• Do not install this unit on the board covering the

spare tire or other places which are subject to

vibration.

• When installing this unit, choose a position that

ensures there will be no contact with luggage.

The impact of a heavy weight or sudden shock on

this unit will adversely affect the accurate display

of the current location of the vehicle.

• Avoid installing this unit in places where it will

interfere with loading and unloading of the spare

tire, jack, tools, etc.

• Install this unit horizontally on a surface within

+30º to –30º tolerance (within 5º to the left or

right of your vehicle's direction of travel). Mis-

installing the unit with the surface tilted more

than these tolerances would increase the potential

for errors in the location display, and might other-

wise cause reduced display performance.

5°

To guard against electromagnetic

interference

In order to prevent interference, set the

following items as far as possible from

this unit, other cables or leads:

- TV antenna and its lead

- Radio antenna and its lead

- GPS antenna and its lead

In addition you should lay or route each

antenna lead as far as possible from other

antenna leads.

Do not bind them together, lay or route

them together, or cross them.

Such electromagnetic noise will increase

the potential for errors in the location dis-

play.

30°